A New Scheme for Parallel Transmission of Power and Full-Duplex Mode Information Sharing with LCC Topology Based on IPT System

Authors

  • T. Manikandan Department of Electrical and Electronics Engineering, National Institute of Technology, Tiruchirappalli, Tamil Nadu, India
  • Panugothu Srinivasan Rao Nayak Department of Electrical and Electronics Engineering, National Institute of Technology, Tiruchirappalli, Tamil Nadu, India
  • Sishaj P. Simon Department of Electrical and Electronics Engineering, National Institute of Technology, Tiruchirappalli, Tamil Nadu, India
  • Kinattingal Sundareswaran Department of Electrical and Electronics Engineering, National Institute of Technology, Tiruchirappalli, Tamil Nadu, India

DOI:

https://doi.org/10.13052/dgaej2156-3306.3828

Keywords:

Inductive power transfer (IPT), LCC topology, amplitude shift keying (ASK), phase shift keying (PSK), LC series, parallel tank

Abstract

In this study, a full-duplex data communication module is designed and developed for sharing information in a contactless power transfer system. It is realized through LC tank circuits with an inductive power transfer (IPT) system. On both the transmitter and receiver sides, one LCC compensation topology is used. Since Phase Shift Keying (PSK) is less susceptible to error and power-efficient digital modulation techniques, this paper proposes to implement PSK digital modulation technique to data signal modulation for full-duplex communication in a wireless EV charger. The proposed scheme ensures stability, transfers load status, charging level, and emergency messages between the source and load sides of the system, and vice versa. The results are compared with the Amplitude Shift Keying (ASK) digital modulation technique. Further, the impedance-based model is developed to analyze the interference between the power and high-frequency information signals. The inductive power and data transfer (IPDT) prototype is developed in the laboratory and results show that the data rate reaches 288 kbps when 46.6 W of power is transferred from source to load.

Downloads

Download data is not yet available.

Author Biographies

T. Manikandan, Department of Electrical and Electronics Engineering, National Institute of Technology, Tiruchirappalli, Tamil Nadu, India

T. Manikandan received the B.E. degree in electronics and communication engineering from Anna University, Chennai, Tamil Nadu India, in 2005; and the M.E. degree in Applied Electronics, from Anna University, Chennai, Tamil Nadu, India, in 2008. Currently, he is pursuing a Ph.D. degree in electrical and electronics engineering from the National Institute of Technology, Tiruchirappalli, Tamil Nadu, India. His research interests include power electronics and wireless power and data transfer systems.

Panugothu Srinivasan Rao Nayak, Department of Electrical and Electronics Engineering, National Institute of Technology, Tiruchirappalli, Tamil Nadu, India

Panugothu Srinivasan Rao Nayak received the B.Tech. degree in electrical and electronics engineering from Bapatla Engineering College (BEC), Bapatla, Guntur, in 2001; the MTech. degree in energy systems from Jawaharlal Nehru Technological University (JNTU), Hyderabad, Telangana, India, in 2006; and the Ph.D. degree in electrical engineering from the National Institute of Technology, Tiruchirappalli, Tamil Nadu, India, in 2014. Currently, he is an Assistant Professor with the Department of Electrical and Electronics Engineering, National Institute of Technology. His research interests include power electronics and drives, biologically inspired optimization techniques, and wireless power transfer systems.

Sishaj P. Simon, Department of Electrical and Electronics Engineering, National Institute of Technology, Tiruchirappalli, Tamil Nadu, India

Sishaj P. Simon received the B.Eng. degree in electrical and electronics engineering from Bharathiar University, Coimbatore, Tamil Nadu, India, in 1999 and the M.Eng. degree in applied electronics from Bharathiar University, Coimbatore, Tamil Nadu, India, in 2001; and the Ph.D. degree in power system engineering from Indian Institute of Technology (IIT), Roorkee, Uttarakhand, India, in 2006. Currently, he is an Associate Professor with the Department of Electrical and Electronics Engineering, National Institute of Technology (NIT). His research interests include the area of power system operation and control, power system planning and reliability, artificial neural networks, fuzzy logic systems, and application of meta-heuristics, and intelligent techniques to power systems.

Kinattingal Sundareswaran, Department of Electrical and Electronics Engineering, National Institute of Technology, Tiruchirappalli, Tamil Nadu, India

Kinattingal Sundareswaran received the B.Tech. (Hons.) degree in electrical and electronics engineering power electronics from the University of Calicut, Calicut, Kerala, India, in 1988 and MTech. (Hons.) degree from the University of Calicut, Calicut, Kerala, India, in 1991; and the Ph.D. degree in electrical engineering from Bharathidasan University, Tiruchirappalli, Tamil Nadu, India, in 2001. He is currently a Professor with the Department of Electrical and Electronics Engineering, National Institute of Technology, Tiruchirappalli, Tamil Nadu, India. His research interests include power electronics, renewable energy systems, and biologically inspired optimization techniques.

References

A. Khaligh, S. Dusmez, “Comprehensive topological analysis of conductive and inductive charging solutions for plug-in electric vehicles”, IEEE Transactions Vehicular Technology, 2012, 61(8):3475–3489.

G. A. Covic, J. T. Boys, “Modern trends in inductive power transfer for transportation applications”, IEEE Journal of Emerging Selected Topics in Power Electronics, 2013,1(1):28–41.

S. Li, C. Mi, “Wireless Power Transfer for Electric Vehicle Applications”, IEEE Journal on Emerging and Selected Topics in Power Electronics, 2015, 3(1):4–17.

A. A. S. Mohamed, A. A. Marim, O. A. Mohammed, “Magnetic design considerations of bidirectional inductive wireless power transfer system for EV applications”, IEEE Transactions on Magnetics,2016, 53(6):1–8.

L. Huang, G. Meunier, O. Chadebec, “General integral formulation of magnetic flux computation and its application to inductive power transfer system”, IEEE Transactions on Magnetics, 2017, 53(6):14–21.

C. C. Mi, G. Buja, S. Y. Choi, and C. T. Rim, “Modern advances in wireless power transfer systems for roadway powered electric vehicles,” IEEE Trans. Ind. Electron., vol. 63, no. 10, pp. 6533–6545, Oct. 2016.

Đurić, Radivoje, and Milan Pajnić. “Design of compensation network with variable inductance wide variation of coupling coefficient in inductive power transfer.” International Journal of Circuit Theory and Applications 47, no. 11 (2019): 1786–1799.

Q. Hu, D. Hu, B. Duan, and J. He. “A fully implantable stimulator with wireless power and data transmission for experimental investigation of epidural spinal cord stimulation”, IEEE Trans. Neural Syst. Rehabil. Eng, 2015, 23(4):683–692.

T. Bieler, M. Perrottet, V. Nguyen, Y. Perriard, “Wireless power and data transmission”, IEEE Trans. Ind. Electron, 2002, 38(5):1266–1272.

K. Dostert. Powerline communications. Englewood Cliffs, NJ: Prentice-Hall,2001.

M.H. Shwehdi, A.Z. Khan, “A Power line data communication interface using spread spectrum technology in home automation”, IEEE Transaction on Power Delivery, 1996, 11(3):1232–1237.

Xiaofei, Chunsen Tang, Xin Dai, Pengqi Deng, Yugang Su, “An Inductive and Capacitive Combined Parallel Transmission of power and Data for Wireless Power Transfer Systems”, IEEE Transactions on Power Electronics, 2018, 33(6):4980–4991.

Chih-Cheng Huang, Chun-Liang Lin, Yuan-Kang Wu, “Simultaneous Wireless Power/Data Transfer for Electric Vehicle Charging”, IEEE Transactions on Industrial Electronics, 2017, 64(1):682–690.

Jin-Guk Kim, Guo Wei, Man-Ho Kim, Hyok-Su-Ryo and Chunbo Zhu, “A Wireless Power and Information Simultaneous Transfer Technology Based on 2FSK Modulation Using the Dual Bands of Series-Parallel Combined Resonant Circuit”, IEEE Transactions on Power Electronics, 2019, 34(3):2956–2965.

Ji. L. Wang, C. Liao and S. Li, “Simultaneous Wireless Power and Bidirectional Information Transmission with a Single-Coil Dual-Resonant Structure”, IEEE Transactions on Industrial Electronics, 2019, 66(5):4013–4022.

J. Wu, C. Zhao, Z. Lin, J. Du, Y. Hu, and X. He, “Wireless power and data transfer via a common inductive link using frequency division multiplexing”, IEEE Trans. Ind. Electron. 2015, 62(12):7810–7820.

Zhongnan Qian, Rui Yan, Jiande and Xiangning He, “Full-Duplex High-Speed Simultaneous Communication Technology”, IEEE Transactions on Power Electronics. 2019, 34(10):9369–9373.

P. Srinivasa Rao Nayak, Dharavath Kishan, “Performance analysis of series/parallel and dual side LCC compensation topologies of inductive power transfer for EV battery charging system”, Front Energy, 2020, 14(1):166–179.

Yue Sun, Peng-Xu Yan, Zhi-Hui Wang, Ying-Ying Luan, “The Parallel Transmission of Power and Data with the Shared Channel for an Inductive Power Transfer System”, IEEE Transactions on Power Electronics, 2016, 31(8):5495–5502.

T. Manikandan, P. Srinivasa Rao Nayak, K. Sundareswaran. A new technique for power transmission and full duplex communication employing SN IPT system. Int J Circ Theor Appl. 2021;1–12. doi: 10.1002/cta.3165.

Yuan Shuang Fan, Yue Sun, Xin Dai, Zhiping Zuo and Anhong You, “Simultaneous Wireless Power Transfer and Full-Duplex Communication with a Single Coupling Interface”, IEEE Transactions on Power Electronics, vol. 36, No. 6, June 2021.

Downloads

Published

2023-01-03

How to Cite

Manikandan, T. ., Nayak, P. S. R. ., Simon, S. P. ., & Sundareswaran, K. . (2023). A New Scheme for Parallel Transmission of Power and Full-Duplex Mode Information Sharing with LCC Topology Based on IPT System. Distributed Generation &Amp; Alternative Energy Journal, 38(02), 547–568. https://doi.org/10.13052/dgaej2156-3306.3828

Issue

2023: Vol 38 Iss 2

Section

Articles