Design and Realization of a Wideband Microstrip Filter Using Signal- Interaction Techniques

Authors

  • Lixue Zhou 1 National Key Laboratory of Science and Technology on Antennas and Microwaves Xidian University, Xi’an 710101, P. R. China 2 Department of Microwave Engineering Xi’an Electronic Engineering Research Institute, Xi’an 710100, P. R. China
  • YingZeng Yin National Key Laboratory of Science and Technology on Antennas and Microwaves Xidian University, Xi’an 710101, P. R. China
  • Wei Hu National Key Laboratory of Science and Technology on Antennas and Microwaves Xidian University, Xi’an 710101, P. R. China
  • Xi Yang National Key Laboratory of Science and Technology on Antennas and Microwaves Xidian University, Xi’an 710101, P. R. China

Keywords:

Passband, phase inverter, transmission path, transmission pole, transmission Zero

Abstract

The signal-interaction techniques are adopted in this paper to design a novel wideband microstrip filter. The signal is transmitted from input port to the output one through two transmission paths in parallel which is composed of a wideband 180° inverter based on microstrip line and a 3?/4 transmission line. Besides, two ?/4 shorted-ended lines is employed to improve the passband transmission performance of the BPF (Bandpass Filter). It is demonstrated from the simulation and measurement results of the novel BPF that three transmission zeros leading to the good harmonic suppression performance are achieved for the BPF operating from 0.99 to 2.51 GHz with 3-dB fractional bandwidth of 86.8%.

Downloads

Download data is not yet available.

References

W. Menzel, L. Zhu, K. Wu, and F. Bogelsack, “On the design of novel compact broadband planar filters,” IEEE Trans. Microw. Theory Tech., vol. 51, no. 2, pp. 364-369, Feb. 2003.

L. Zhu, S. Sun, and W. Menzel, “Ultra-wideband (UWB) bandpass filters using multiple-mode resonator,” IEEE Microw. Wireless Compon. Lett., vol. 15, no. 11, pp. 796-798, Nov. 2005.

P. K. Singh, S. Basu, and Y.-H. Wang, “Planar ultra-wideband bandpass filter using edge coupled microstrip lines and stepped impedance open stub,” IEEE Microw. Wireless Compon. Lett., vol. 17, no. 9, pp. 649-652, Sep. 2008.

J. Garcia-Garcia, J. Bonache, and F. Martin, “Application of electromagnetic bandgaps to the design of ultra-wide bandpass filters with good outof-band performance,” IEEE Trans. Microw. Theory Tech., vol. 54, no. 12, pp. 4136-4140, Dec. 2006.

C. W. Tang and M. G. Chen, “A microstrip ultrawideband bandpass filter with cascaded broadband bandpass and bandstop filters,” IEEE Trans. Microwave Theory Tech., vol. 55, no. 11, pp. 2412- 2418, Nov. 2007.

A. Boutejdar, A. Batmanov, M. H. Awida, E. P. Burte, and A. Omar, “Design of a new bandpass fitler with sharp transmission band using multilayertechnique and U-defected ground structure,” IET Microwaves, Antennas and Propagation, vol. 4, no. 9, pp. 1415-1420, Apr. 2010.

A. Boutejdar, A. Elsherbini, A. Balalem, J. Machac, and A. Omar, “Design of new DGS hairpain microstrip bandpass filter using coupling matrix method,” Progress In Electromagnetics Research Symposium, Prague, pp. 261-265, 2007.

A. Boutejdar, “A new approach to design compact tunable BPF starting from simple LPF topology using a single T-DGS-resonator and ceramic capacitors,” Microw. Opt. Technol. Lett., vol. 58, no. 5, pp. 1142-1148, May 2016.

A. Boutejdar, “Design of 5 GHz-compact reconfigurable DGS-bandpass filter using varactordiode device and coupling matrix technique,” Microw. Opt. Technol. Lett., vol. 58, no. 2, pp. 304- 309, Feb. 2016.

R. Gómez-García and J. I. Alonso, “Design of sharp-rejection and low-loss wide-band planar filters using signal-interference techniques,” IEEE Microw. Wireless Compon. Lett., vol. 15, no. 8, pp. 530-532, Aug. 2005.

R. Gómez-García, M. Sánchez-Renedo, B. Jarry, J. Lintignat, and B. Barelaud, “A class of microwave transversal signal-interference dual passband planar filters,” IEEE Microw. Wireless Compon. Lett., vol. 19, no. 3, pp. 158-160, Mar. 2009.

M. A. Sánchez-Soriano, E. Bronchalo, and G. Torregrosa-Penalva, “Compact UWB bandpass filter based on signal interference techniques,” IEEE Microw. Wireless Compon. Lett., vol. 19, no. 11, pp. 692-694, Nov. 2009.

W. Feng and W. Che, “Novel ultra-wideband bandpass filter using shorted coupled lines and transversal transmission line,” IEEE Microw. Wireless Compon. Lett., vol. 20, no. 10, pp. 548- 551, Oct. 2010.

K. W. Wong, L. Chiu, and Q. Xue, “Wideband parallel-strip bandpass filter using phase inverter,” IEEE Microw. Wireless Compon. Lett., vol. 18, no. 8, pp. 503-505, Aug. 2008.

M. E. Bialkowski and Y. Wang, “Wideband microstrip 180° hybrid utilizing ground slots,” IEEE Microw. Wireless Compon. Lett., vol. 20, no. 9, pp. 495-497, Sept. 2010.

M. K. Mandal and S. Sanyal, “Compact bandstop filter using signal interference technique,” IEEE Electron. Lett., vol. 43, no. 2, pp. 110-111, Jan. 2007.

Downloads

Published

2021-08-18

How to Cite

[1]
L. . Zhou, Y. . Yin, W. . Hu, and X. . Yang, “Design and Realization of a Wideband Microstrip Filter Using Signal- Interaction Techniques”, ACES Journal, vol. 31, no. 05, pp. 562–567, Aug. 2021.

Issue

Section

Articles