A Novel Compact Low-Pass Filter using Defected Ground Structure for Sharp Transition Band

Authors

  • A. Mohammadi Microelectronic Research Laboratory, Urmia University, Urmia 57159, Iran
  • M. N. Azarmanesh Microelectronic Research Laboratory, Urmia University, Urmia 57159, Iran

Keywords:

Bandpass, band-reject, defected ground structure (DGS), maximally flat prototype, roll-off rate

Abstract

This paper presents a simple technique to design a low-pass filter using defected ground structure (DGS) having a remarkable sharp response in transition band and rejection better than -20 dB up to 20 GHz. The fabricated filter has a 3 dB cutoff frequency at 3.4 GHz and it is as small as 22 mm × 12 mm. The insertion loss in the pass-band is less than 0.6 dB from DC to 3.1 GHz. The design of the filter is simple and it gives desired frequency response. Measured results show good agreement with simulated ones.

Downloads

Download data is not yet available.

References

A. Rahman, A. Verma, A. Boutejdar, and A. Omar, "Control of bandstop response of Hi-Lo microstrip lowpass filter using slot in ground plane," IEEE Trans. Microw. Theory Tech., vol. 52, pp. 1008-1013, 2004.

J. Lim, C. Kim, D. Ahn, Y. Jeong, and S. Nam, "Design of low-pass filters using defected ground structure," IEEE Trans. Microw. Theory Tech., vol. 53, pp. 2539-2545, 2005.

A. Kumar and A. Verma, "Design of compact seven poles low pass filter using defected ground structure," in International Conference on Emerging Trends in Electronic and Photonic Devices & Systems, Varanasi, 2009.

A. Kumar and A. Verma, "Compact low pass bessel filter using microstrip DGS structure," in Proceedings of Asia-Pacific Microwave Conference, Yokohama City, 2010.

S. Ting, K. Tam, and R. Martins, "Miniaturized microstrip lowpass filter with wide stopband using double equilateral U-shaped defected ground structure," IEEE Microwave and Wireless Components Lett., vol. 16, no. 5, pp. 240-242, 2006.

D. Pozar, Microwave Engineering, New York, John Wiley & Sons, Inc., pp. 392-398, 2005.

A. Verma and A. Kumar, "Synthesis of microstrip lowpass filter using defected ground structures," IET Microw. Antennas Propag., vol. 5, no. 12, pp. 1431-1439, 2011.

S. Rehman, A. Sheta, and M. Alkanhal, "Compact bandstop filter using defected ground structure (DGS)," in Electronics, Communications and Photonics Conference (SIECPC), Saudi International, Riyadh, 2011.

Ansoft HFSS V13.

A. Safwat, S. Tretyakov, and A. Raisanen, "Defected ground and patch-loaded planar transmission lines," IET Microwaves, Antennas & Propagation, vol. 3, no. 2, pp. 195-204, 2009.

M. Sharkawy, A. Boutejdar, F. Alhefnawi, and O. Luxor, "Improvement of compactness of lowpass/bandpass filter using a new electromagnetic coupled crescent defected ground structure resonators," Applied Computational Electromagnetics Society (ACES) Journal, vol. 25, no. 7, pp. 570-577, 2010.

A. Verma and A. Kumar, "Design of low filters using some defected ground structures," International Journal of Electronics and Communications (AEÜ), vol. 65, no. 10, pp. 864 872, 2011.

T. Edwards and M. Steer, Interconnect and Microstrip Design Sons, Ltd., pp. 93, 2000.

Downloads

Published

2021-09-07

How to Cite

[1]
A. . Mohammadi and M. N. . Azarmanesh, “A Novel Compact Low-Pass Filter using Defected Ground Structure for Sharp Transition Band”, ACES Journal, vol. 29, no. 01, pp. 84–90, Sep. 2021.

Issue

Section

Articles