Linear Dielectric Resonator Array Fed by N-Way Bow-Tie Shaped Dielectric Resonator Power Divider

Authors

  • L. Hady Salman Department of Electrical Engineering, The University of Mississippi, MS 38677, USA
  • A. Kishk Department of Electrical and Computer Engineering, Concordia University, Montreal, QC, Canada H3G 1M8
  • D. Kajfez Department of Electrical Engineering, The University of Mississippi, MS 38677, USA

Keywords:

Antenna array feed, bow-tie shaped dielectric resonators, higher-order modes, power divider, X-band

Abstract

The concept of using high order modes of a bow-tie shaped dielectric resonator in the design of N-way power divider is presented in this paper. The design of 6-way power divider operating at X-band frequency range is illustrated, simulated and tested for concept validation. The combination of probe type excitation and microstrip technology is used to excite an Hpolarized resonating mode around 10 GHz. Both input matching and in phase tapered power distribution are experimentally maintained within 150 MHz frequency band around the resonant frequency. Measured scattering parameters magnitude and phase of the proposed 7-port structure are shown to verify the expected simulation results. Also, the proposed power divider is used to excite an antenna array of six rectangular dielectric resonators using narrow slots coupled to the power divider output through microstrip lines. Good agreement between simulated and measured results is obtained for application validation.

Downloads

Download data is not yet available.

Downloads

Published

2021-09-27

How to Cite

[1]
L. H. . Salman, . A. . Kishk, and D. . Kajfez, “Linear Dielectric Resonator Array Fed by N-Way Bow-Tie Shaped Dielectric Resonator Power Divider”, ACES Journal, vol. 28, no. 10, pp. 924–930, Sep. 2021.

Issue

Section

Articles