Design of a Half-Mode SIW High-Pass Filter

Authors

  • Wei Shao Institute of Applied Physics University of Electronic Science and Technology of China, Chengdu, 610054, P. R. China
  • Jia-Lin Li Institute of Applied Physics University of Electronic Science and Technology of China, Chengdu, 610054, P. R. China

Keywords:

Design of a Half-Mode SIW High-Pass Filter

Abstract

A planar high-pass filter with simple topology, low insertion loss and high power handling is presented in this paper. It is based on the half-mode substrate-integrated waveguide (SIW) structure whose shorting wall is implemented with periodical via-holes. Meanwhile, bevel edges are embedded to achieve good impedance matching. Parameter studies are also performed to give design insights for practical applications. A planar waveguide filter with cutoff frequency of 10 GHz is designed and built. The measured data have a good agreement with the simulated responses, and demonstrate practical utility of the proposed topology.

Downloads

Download data is not yet available.

References

C. Zhong, J. Xu, Z.-Y. Yu, M.-Y. Wang, and

J.-H. Li, “Half Mode Substrate Integrated

Waveguide Broadband Bandpass Filter,”

Progress In Electromagn. Research Lett.,

vol. 4, pp. 131-138, 2008.

Z. Sotoodeh, B. Biglarbegian, F. Hojat

Kashani, and H. Ameri, “A Novel Bandpass

Waveguide Filter Structure on SIW

Technology,” Progress In Electromagn.

Research Lett., vol. 2, pp. 141-148, 2008.

Q. Lai, C. Fumeaux, W. Hong, and R.

Vahldieck, “Characterization of the

Propagation Properties of the Half-Mode

Substrate Integrated Waveguide,” IEEE Trans.

Microwave Theory Tech., vol. MTT-57, pp.

-2004, 2009.

C. Zhong, J. Xu, Z.-Y. Yu, M.-Y. Wang, and

J. Li, “Half Mode Substrate Integrated

Waveguide Broadband Bandpass Filter using

Photonic Band Gap Structures,” International

Conf. on Microw. and Millimeter Wave

Technol., ICMMT, pp. 22-24, 2008.

E. Mehrshahi and M. Salehi, “A Simple

Technique for Propagation Characteristics of

Substrate Integrated Waveguide,” Applied

Computational Electromagn. Society Journal,

vol. 25, no. 8, pp. 690-695, 2010.

A. Boutejdar, G. Nadim, and A. S. Omar,

“Compact Bandpass Filter Structure using an

Open Stub Quarter-Wavelength Microstrip

Line Corrections,” Proc. 35th EuMC (Paris),

ACES JOURNAL, VOL. 26, NO. 5, MAY 2011

U. Rosenberg, S. Amari, J. Bornemann, and R.

Vahldieck, “Compact Pseudo-Highpass Filters

Formed by Cavity and Iris Resonators,” 34th

European Microw. Conf., pp. 985–988, 2004.

A. Toscano, L. Vegni, and F. Urbani,

“Exponentially Tapered Nonuniform

Transmission Lines for High-Pass Filter

Design,” Microwave Opt. Technol. Lett., vol.

, no 4, pp. 227-229, 1997.

F. Gianesello, D. Gloria, C. Raynaud, C.

Tinella, P. Vincent, F. Saguin, S. Boret, C.

Clement, B.-V. Haaren, J.-M. Fournier, G.

Dambrine, and P. Benech, “Integration of

Ultra Wide Band High Pass Filter using High

Performance Inductors in Advanced High

Resistivity SOI CMOS Technology,” Silicon

RF Conf., pp. 248-251, 2006.

C. Li, K.-Y. Liu, and F. Li, “Design of

Microstrip Highpass Filters with

Complementary Split Ring Resonators,”

Electron. Lett., vol. 43, no. 1, pp. 35-36, 2007.

P. Mondal, and A. Chakrabarty, “Compact

Highpass Filter using Complementary Split

Ring Resonator,” Microwave Opt. Technol.

Lett., vol. 49, no. 10, pp. 2469-2471, 2007.

S. Misan, R. Haviv, D. Ackerman, H.

Matzner, and M. Haridim, “A High-Pass Filter

Based on Modified Double-Sided Parallel-

Strip Lines,” Microwave Opt. Technol. Lett.,

vol. 51, no. 11, pp. 2691-2694, 2009.

J. Chramiec, R. Kieda, and M. kitlinski,

“Full-Wave Simulation of Microstrip Line

with Short-Circuited Edge,” 15th int. Conf.

Microwave, Radar and Wireless

Communications, pp. 222-224, 2004.

J. Chramiec, M. Kitlinski, and B.-J. Janiczak,

“Microstrip Line with Short-Circuited Edge as

a High-Pass Filter Operating up to Millimeter-

Wave Frequencies,” Microwave Opt. Technol.

Lett., vol. 49, no. 9, pp. 2177-2179, 2007.

K.-M. Noujeim, “High-Pass Filtering

Characteristics of Transmission-Line Combs,”

IEEE Trans. Microwave Theory Tech., vol.

MTT-57, pp. 2743-2752, 2009.

W. Hong, B. Liu, Y. Wang, Y. Wang, Q. Lai,

H. Tang, X. X. Yin, Y. D. Dong, Y. Zhang,

and K. Wu, “Half Mode Substrate Integrated

Waveguide: A New Guided Wave Structure

for Microwave and Millimeter Wave

Application,” IRMMW-THz, pp. 219, 2006.

Ansoft HFSS, ver. 10, ANSYS, Inc.,

Canonsburg, PA. Available: http:

//www.ansoft.com/products/hf/hfss/

X.-P. Chen, K. Wu, and Z.-L. Li, “Dual-Band

and Triple-Band Substrate Integrated

Waveguide Filters with Chebyshev and Quasi-

Elliptic Responses,” IEEE Trans. Microwave

Theory Tech., vol. MTT-55, pp. 2569-2578,

D. Deslandes and K. Wu, “Accurate

Modeling, Wave Mechanisms, and Design

Considerations of a Substrate Integrated

Waveguide,” IEEE Trans. Microwave Theory

Tech., vol. MTT-54, pp. 2516-2526, 2006.

ZVA40 vector analyzer, Rohde & Schwarz,

Co., Munich, Germany. Available: http:

//www2.rohde-schwarz.com/en/products/test_

and_measurement/network_analysis/ZVA/.

Downloads

Published

2022-05-02

How to Cite

[1]
W. . Shao and J.-L. . Li, “Design of a Half-Mode SIW High-Pass Filter”, ACES Journal, vol. 26, no. 5, pp. 447–451, May 2022.

Issue

Section

General Submission