Design and Analysis of Microstrip Photonic Band Gap Filter for Suppression of Periodicity
Keywords:
Design and Analysis of Microstrip Photonic Band Gap Filter for Suppression of PeriodicityAbstract
A design for a microstrip band reject filter is presented in this paper. The proposed filter is compact in structure and provides an accurate band gap. Optimized length is applied to photonic band gap (PBG) structures etched in the ground plane for suppressing periodicity in the frequency response. Detailed analysis of the frequency response of the conventional microstrip filter along with the PBG filter has been carried out in this paper.
Downloads
References
K. L. Finch and N. G. Alexopoulos, “Shunt
posts in microstrip transmission lines”, IEEE
Trans. Microwave Theory Tech., vol.
MMT.-38, pp. 1585-1594, 1990.
J.-S. G. Hong and M.J. Lancaster,
Microstrip Filters for RF/Microwave
Applications, John Wiley & Sons Inc, 2001.
D. M. Pozar, Microwave Engineering , John
Wiley, 2000.
IE3D Software Release – 8, Developed by
M/s Zeland Software Inc.
J. D. Joannopoulos et al., Photonic Crystals:
Molding the flow of light , Princeton
University Press, 2000.
A. D’Ozario, et al., “Tapered Photonic Band
Gap Microstrip Low Pass Filter: Design and
Realisation”, IEEE Proc. Microwave
Antenna Propag. , vol. 150, n o. 6, pp. 459-
, 2003.
V. Radisic, et al., “Novel 2-D Photonic
Band Gap structure for microstrip lines”,
IEEE Microwave guided wave Letter, vol. 8,
no. 2, pp. 69-71, 1998.
T. Lopetegi et al., “Novel band gap
microstrip structures using network
topology”, Microwave Opt. Letter, vol. 25,
no. 1, pp.411-412, 1999.
