Optimization of Wireless Power Transmission Systems with Parasitic Wires

Authors

  • K. H. Yeap Universiti Tunku Abdul Rahman, Kampar, Perak 31900, Malaysia
  • A. R. C. Cheah Universiti Tunku Abdul Rahman, Kampar, Perak 31900, Malaysia
  • K. Hirasawa Universiti Tunku Abdul Rahman, Kampar, Perak 31900, Malaysia
  • K. C. Yeong Universiti Tunku Abdul Rahman, Kampar, Perak 31900, Malaysia
  • K. C. Lai Universiti Tunku Abdul Rahman, Kampar, Perak 31900, Malaysia
  • H. Nisar Universiti Tunku Abdul Rahman, Kampar, Perak 31900, Malaysia

Keywords:

Antennas, method of moments, simulated annealing, wireless power transmission

Abstract

We present a rigorous optimization method to design wireless power transmission (WPT) systems. In order to optimize the power coupled to the receiver, reactive parasitic components are integrated into the system. Simulated annealing is implemented in conjunction with the method of moments to determine the optimum parameters for the design. By carefully adjusting the geometry, size, position and properties of the parasitic wires, it could be seen that the peak efficiency and effective distance for power coupling could be significantly improved. The result shows that the implementation of a square parasitic wire gives better performance than a circular one. A WPT system with a square reactive wire gives respectively a 0.79% and 0.07 lambda improvement in peak efficiency and effective distance compared to its zero-impedance counterpart. By inserting two square reactive wires with the transmitter sandwiched in between, the peak efficiency and effective distance are found to have increased respectively by 3.37% and 0.18 lambda, compared to that with a single reactive wire.

Downloads

Download data is not yet available.

References

X. Jin, J. M. Caicedo, and M. Ali, “Near-field wireless power transfer to embedded smart sensor antennas in concrete,” ACES J., vol. 30, no. 3, pp. 261-269, 2015.

A. Kurs, A. Karalis, R. Moffatt, J. D. Joannopoulos, P. Fisher, and M. Soljacic, “Wireless power transfer via strongly coupled magnetic resonances,” Science Express, vol. 317, no. 5834, pp. 83-86, 2007.

M. D. Migliore, D. Pinchera, and F. Schettino, “A simple and robust adaptive parasitic antenna,” IEEE Transactions on Antennas and Propagation, vol. 53, no. 10, pp. 3262-3272, 2005.

K. Hirasawa and M. Haneishi, Analysis, Design and Measurement of Small and Low-Profile Antennas. 1st ed., Boston, USA, Artech House, 1992.

D. Bertsimas and J. Tsitsiklis, “Simulated annealing,” Statistical Science, vol. 8, no. 1, pp. 10- 15, 1993.

A. R. C. Cheah, K. H. Yeap, K. C. Yeong, and K. Hirasawa, “Biologically inspired wireless power transmission system: A review,” In: V. Ponnusamy, N. Zaman, T. J. Low, and A. H. M. Amin, Biologically-Inspired Energy Harvesting Through Wireless Sensor Technologies. 1st ed., Hershey PA, USA, IGI Global, pp. 27-50, 2016.

A. R. C. Cheah, K. H. Yeap, K. Hirasawa, K. C. Yeong, and H. Nisar, “Optimization of a wireless power transmission system”, in Proc. of the Int. MultiConference of Engineers and Computer Scientists; Hong Kong, pp. 590-592, 2016.

Downloads

Published

2021-07-30

How to Cite

[1]
K. H. Yeap, A. R. C. Cheah, K. Hirasawa, K. C. Yeong, K. C. Lai, and H. Nisar, “Optimization of Wireless Power Transmission Systems with Parasitic Wires”, ACES Journal, vol. 32, no. 09, pp. 806–812, Jul. 2021.

Issue

Section

General Submission