Compact Bandpass Filter with Sharp Out-of-band Rejection and its Application

Authors

  • Lixue Zhou 1 National Key Laboratory of Science and Technology on Antennas and Microwaves Xidian University, Xi’an 710071, P. R. China 2 Microwave Engineering of Department Xi’an Electronic Engineering Research Institute, Xi’an 710100, P. R. China
  • YingZeng Yin National Key Laboratory of Science and Technology on Antennas and Microwaves Xidian University, Xi’an 710071, P. R. China
  • Wei Hu National Key Laboratory of Science and Technology on Antennas and Microwaves Xidian University, Xi’an 710071, P. R. China
  • Xi Yang National Key Laboratory of Science and Technology on Antennas and Microwaves Xidian University, Xi’an 710071, P. R. China

Keywords:

Harmonic suppression, multiplier, output power, passband, T-shaped structure, transmission zero

Abstract

A novel compact bandpass filter considered as the harmonic suppression circuit is designed in this paper. Because of the application of a T-shaped structure, the filter is improved in performance and reduced in size. Two transmission zeros at passband edge can be conveniently adjusted by changing the length of the open stubs located at the center of the T-shaped structure. Two filters with different open-stub structures are designed. Good agreement between the simulation and the measurement is acquired, which verifies the theoretical predictions. Benefiting from this feature, an active frequency multiplier with the proposed filter as the output matching network is designed. When input signal is set to be 6 dBm, output power of the second harmonic varies from 6 to 8 dBm with 20 dBc suppression for the first, third and fourth harmonics.

Downloads

Download data is not yet available.

References

P. K. Singh, S. Basu, and Y.-H. Wang, “Planar ultra-wideband bandpass filter using edge coupled microstrip lines and stepped impedance open stub,” IEEE Microw. Wireless Compon. Lett., vol. 17, no. 9, pp. 649-652, Sep. 2008.

L. Zhu, H. Shi, and W. Menzel, “Coupling behaviors of quarter wavelength impedance transformers for wideband CPW bandpass filters,” IEEE Microw. Wireless Compon. Lett., vol. 15, no. 1, pp. 13-15, Jan. 2005.

C.-Y. Hung, M.-H. Weng, Y.-K. Su, and R.-Y. Yang, “Design of parallel coupled-line microstrip wideband bandpass filter using stepped-impedance resonators,” Microw. Opt. Technol. Lett., vol. 49, no. 4, pp. 795-798, Feb. 2007.

C. L. Hsu, F. C. Hsu, and J. T. Kuo, “Microstrip bandpass filters for ultra-wideband (UWB) wireless communications,” IEEE MTT-S Int. Microw. Symp. Dig., pp. 679-682, June 2005.

J. Garcia-Garcia, J. Bonache, and F. Martin, “Application of electromagnetic bandgaps to the design of ultra-wide bandpass filters with good out-of-band performance,” IEEE Trans. Microw. Theory Tech., vol. 54, no. 12, pp. 4136-4140, Dec. 2006.

A. Boutejdar, A. Batmanov, M. H. Awida, E. P. Burte, and A. Omar, “Design of a new bandpass fitler with sharp transmission band using multilayertechnique and U-defected ground structure,” IET Microwaves, Antennas and Propagation, vol. 4, no. 9, pp. 1415-1420, Apr. 2010.

J.-S. Lim, C.-S. Kim, D. Shn, Y.-C. Jeong, and S. Nam, “Design of low-pass filters using defected ground structure,” IEEE Trans. Microw. Theory Tech., vol. 53, no. 8, pp. 2539-2545, Aug. 2005.

R. Gómez-García and J. I. Alonso, “Design of sharp-rejection and low-loss wide-band planar filters using signal-interference techniques,” IEEE Microw. Wireless Compon. Lett., vol. 15, no. 8, pp. 530-532, Aug. 2005.

R. Gómez-Garciá, “High-rejection wideband signalinterference microstrip filters using rat-race couplers,” Electron. Lett., vol. 42, no. 20, pp. 1162-1163, Sep. 2005.

J. R. Lee, J. H. Cho, and S. W. Yun, “New compact bandpass filter using microstrip λ/4 resonators with open stub inverter,” IEEE Microw. Microw. Guide Wave Lett., vol. 10, no. 12, pp. 526-527, Dec. 2000.

J. T. Kuo, W. H. Hsieh, and M. Jiang. “Design of two-stage UIR and SIR bandpass filters with an elliptic function-like response,” IEEE MTT-S Int. Microw. Symp. Dig., pp. 1609-1612, June 2004.

H. Gan, D. W. Lou, and D. X. Yang. “Compact microstrip bandpass filter with sharp transition bands,” IEEE Microw. Wireless Compon. Lett., vol. 16, no. 3, pp. 107-109, Mar. 2006.

Y. Park, “Class-F technique as applied to active frequency multiplier designs,” IEEE Trans. Microw. Theory Tech., vol. 57, no. 12, pp. 3212-3218, Dec. 2009.

D. G. Thomas and G. R. Branner, “Optimization of active microwave frequency multiplier performance utilizing harmonic terminating impedances,” IEEE Trans. Microw. Theory Tech., vol. 44, no. 12, pp. 2617-2624, Dec. 1996.

S. Maas, Nonlinear Microwave Circuits. Norwood, MA: Artech House, pp. 59-80, 1988.

J. Xu, “Compact dual-wideband BPF based on quarter-wavelength open stub loaded halfwavelength coupled-line,” Applied Computational Electromagnetics Society Journal, vol. 30, no. 9, pp. 1024-1028, 2015.

L. X. Zhou, Y. Z. Yin, W. Hu, and X. Yang, “Design and realization of a wideband microstrip filter using signal-interaction techniques,” Applied Computational Electromagnetics Society Journal, vol. 31, no. 5, pp. 562-567, 2016.

Downloads

Published

2021-08-05

How to Cite

[1]
Lixue Zhou, YingZeng Yin, Wei Hu, and Xi Yang, “Compact Bandpass Filter with Sharp Out-of-band Rejection and its Application”, ACES Journal, vol. 32, no. 03, pp. 249–255, Aug. 2021.

Issue

Section

General Submission