Efficient Electromagnetic Scattering Analysis of Open-ended Circular Cavities with Modal MoM Method

Authors

  • A. Aghabarati Department of Electrical Engineering Amirkabir University of Technology, Tehran, Iran
  • P. Dehkhoda Department of Electrical Engineering Amirkabir University of Technology, Tehran, Iran
  • A. Tavakoli Department of Electrical Engineering Amirkabir University of Technology, Tehran, Iran

Keywords:

Electromagnetic scattering, modal moment method, open-ended circular cavity

Abstract

An efficient and accurate technique is introduced to calculate the scattered electromagnetic (EM) fields from an open-ended circular cavity (OECC). In this paper, it is assumed that the OECC is perforated in an infinite perfect electric conductor (IPEC). Then, the scattered fields are calculated using modal Method of Moments. The complexity and computational cost of the encountered quadruple integrals are addressed in detail. Here, the singularities are extracted and resolved. Next, the scattered far field of a circular PEC plate of the same size is calculated by physical optics approximation. The final OECC scattered field is the sum of these two solutions. A very good agreement is observed between the results of this method and full wave numerical simulations and measurements. The proposed approach is highly efficient and accurate over a wide range of frequencies and incidence angles, making it appealing for analysis of large frequency dispersive structures.

Downloads

Download data is not yet available.

References

H. T. Anastassiu, “A review of electromagnetic scattering analysis for inlets, cavities, and open ducts,” IEEE Trans. Antennas Propagat., vol. 45, no. 6, pp. 27-40, 2003.

J. M. Jin and J. L. Volakis, “A finite element boundary integral formulation for scattering by three dimensional cavity-backed apertures,” IEEE Trans. Antennas Propagat., vol. 39, no. 1, pp. 97- 104, 1991.

J. Liu and J. M. Jin, “A special higher order finite element method for scattering by deep cavities,” IEEE Trans. Antennas Propagat., vol. 48, no. 5, pp. 694-703, 2000.

W. Rachowicz and A. Zdunek, “An hp-adaptive finite element method for scattering problems in electromagnetics,” International Journal of Numerical Methods in Engineering, vol. 62, no. 9, pp. 1226-1249, 2005.

H. Ling, “RCS of waveguide cavities: A hybrid boundary integral/modal approach,” IEEE Trans. Antennas Propagat., vol. 38, no. 9, pp. 1413-1420, 1990.

T. T. Chia, R. J. Burkholder, and R. Lee, “The application of FDTD in hybrid methods for cavity scattering analysis,” IEEE Trans. Antennas Propagat., vol. 43, no. 10, pp. 1082-1090, 1995.

C. A. Chuang and P. H. Pathak, “Ray analysis of modal reflection for three dimensional open-ended cavities,” IEEE Trans. Antennas Propagat., vol. 37, pp. 339-346, 1989.

H. S. Ling, W. Lee, and R. C. Chou, “High frequency RCS of open cavities with rectangular and circular cross sections,” IEEE Trans. Antennas Propagat., vol. 37, no. 5, pp. 648-654, 1989.

A. G. Pino, F. Obelleiro, and J. L. Rodriguez, “Scattering from conducting open cavities by generalized ray expansion (GRE),” IEEE Trans. Antennas Propagat., vol. 41, no. 7, pp. 989-992, 1993.

A. Zdunek and W. Rachowicz, “hp-adaptive CEM in practical applications,” In Spectral and High Order Methods for Partial Differential Equations, Springer Berlin Heidelberg, pp. 339-346, 2011.

A. Zdunek and W. Rachowicz, “Efficient jetengine inlet radar cross-section prediction using higher-order finite-element method and reducedorder modeling,” Electromagnetics, vol. 34, pp. 345-362, 2014.

H. R. Witt and E. L. Price, “Scattering from hollow conducting cylinders,” IEE Proceedings, vol. 115, pp. 94-99, 1968.

H. S. Ling, W. Lee, and R. C. Chou, “High frequency RCS of open cavities with rectangular and circular cross sections,” IEEE Trans. Antennas Propagat., vol. 37, no. 5, pp. 648-654, 1989.

P. H. Patbak, C. W. Chuang, and M. C. Liang, “Inlet Modeling Studies,” Technical Report no. 717674-1, The Ohio State University Electro Science Laboratory, Columbus, OH, 1986.

A. Altintas, P. H. Pathak, and M. C. Liang, “A selective modal scheme for the analysis of EM coupling into or radiation from large open-ended waveguides,” IEEE Trans. Antennas Propagat., vol. 36, pp. 84-96, 1988.

K. K. Chan and F. Tremblay, “Mode matching analysis of metallic blades in a cylinder,” IEEE International Symposium on Antennas and Propagation, Newport Beach, CA, pp. 38-41, June 18-23, 1995.

A. Zdunek and W. Rachowicz. “Cavity radar cross section prediction,” IEEE Trans. Antennas Propagat., vol. 56, no. 6, 2008.

C. T. Tai, Dyadic Green Function in Electromagnetic Theory. 2nd edition, New York: IEEE Press, 1994.

L. F. Shampine, “Vectorized adaptive quadrature in MATLAB,” Journal of Computational and Applied Mathematics, 211, pp. 131-140, 2008.

R. J. Burkholder, P. H. Pathak, and H. T. Chou, “New Ray and Physical Optics Based Methods for Modeling Duct Propagation in the Hybrid Analysis of EM Scattering by Jet Inlets,” Technical Report no. 729526–1, The Ohio State University ElectroScience Laboratory, Columbus, Ohio, 1995.

C. S. Lee and S. W. Lee, “RCS of a coated circular waveguide terminated by a perfect conductor,” IEEE Trans. Antennas Propagat., vol. 35, no. 4, pp. 391-398, 1987

Downloads

Published

2021-08-08

How to Cite

[1]
A. Aghabarati, P. Dehkhoda, and A. Tavakoli, “Efficient Electromagnetic Scattering Analysis of Open-ended Circular Cavities with Modal MoM Method”, ACES Journal, vol. 31, no. 11, pp. 1271–1278, Aug. 2021.

Issue

Section

General Submission