A Finite Difference Time Domain Method for Passive Intermodulation Analysis of Nonlinear Metal-Metal Contact

Authors

  • Tuanjie Li School of Mechano-Electronic Engineering Xidian University, Xi'an, 710071, China
  • Wangmin Zhai School of Mechano-Electronic Engineering Xidian University, Xi'an, 710071, China
  • Xiangyang Li School of Mechano-Electronic Engineering Xidian University, Xi'an, 710071, China
  • Xiaofei Ma Xi’an Institute of Space Radio Technology Xi’an, 710000, China
  • Jie Jiang Honghe University Mengzi, 661100, China

Keywords:

Equivalent circuit model, metal-to-metal contact, passive intermodulation, power level, power series model, time domain finite difference method

Abstract

The passive intermodulation (PIM) has gradually become a serious electromagnetic interference in the high-power and high-sensitivity RF/microwave communication system with the existence of the nonlinear metal-to-metal (MM) contacts. This paper proposes a finite difference time domain (FDTD) method for PIM analysis of nonlinear MM contacts. There are two kinds of models, the power series model and the equivalent circuit model, to describe the nonlinear MM contacts. Then the FDTD method is applied to analyze the nonlinear models so that the nonlinear current through the MM contact can be determined. For the microwave transmission devices, the PIM power level can be obtained by fast Fourier transform of the nonlinear current. For the microwave radiation devices such as antennas, the nonlinear currents are taken as a new electromagnetic transmitting source, the far-field scattering and PIM power level can be obtained by the FDTD method. Finally, a comparison between the simulation and experimental results is illustrated to verify the validity of the proposed method.

Downloads

Download data is not yet available.

References

P. L. Lui and A. D. Rawlins, “Passive nonlinearities in antenna systems,” IEE Colloquium on Passive Intermodulation Products in Antennas & Related Structures, London, pp. 6/1-6/7, 1989.

F. Arazm and F. A. Benson, “Nonlinearities in metal contacts at microwave frequencies,” IEEE Transactions on Electromagnetic Compatibility, vol. EMC-22, no. 3, pp. 142-149, 1980.

J. Jiang, T. J. Li, and Y. C. Liu, “Passive intermodulation scattering analysis of reflector considering contact nonlinearity,” Chinese Journal of Aeronautics, vol. 26, no. 2, pp. 463-469, 2013.

W. Sui, D. A. Christensen, and C. H. Durney, “Extending the two-dimensional FDTD method to hybrid electromagnetic systems with active and passive lumped elements,” IEEE Transactions on Microwave Theory Techniques, vol. 40, no. 4, pp. 724-730, 1992.

C. Vicente and H. L. Hartnagel, “Passive-intermodulation analysis between rough rectangular waveguide flanges,” IEEE Transactions on Microwave Theory & Techniques, vol. 53, no. 8, pp. 2515-2525, 2005.

F. N. Zghoul, “Analyzing single and multitone nonlinear circuits using a modified harmonic balance method,” University of Idaho, Idaho, 2006.

P. Ciampolini, P. Mezzanotte, L. Roselli, and R. Sorrentino, “Accurate and efficient circuit simulation with lumped-element FDTD technique,” IEEE Transactions on Microwave Theory and Techniques, vol. 44, no. 12, pp. 2207-2215, 1996.

H. Jokinen, “Computation of the steady-state solution of nonlinear circuits with time-domain and large-signal-small-signal analysis methods,” Acta Polytechnica Scandinavica Electrical Engineering, vol. 87, pp. 1-75, 1997.

B. R. Poole, S. D. Nelson, and S. Langdon, “Advanced electric and magnetic material models for FDTD electromagnetic codes,” Particle Accelerator Conference, Knoxville, Tennessee, pp. 2639- 2680, 2005.

V. Golikov, S. Hienonen, and P. Vainikainen, “Passive intermodulation distortion measurements in mobile communication antennas,” IEEE 54th Vehicular Technology Conference, vol. 4, pp. 2623-2625, 2001.

J. Jiang, T. J. Li, and X. F. Ma, “A nonlinear equivalent circuit method for analysis of passive intermodulation of mesh reflectors,” Chinese Journal of Aeronautics, vol. 27, no. 4, pp. 924-926. 2014.

S. A. Maas, Nonlinear Microwave and RF Circuits. Artech House Publishers, Norwood, MA, 2003.

O. Rezvanian, M. A. Zikry, C. Brown, and J. Krim, “Surface roughness, asperity contact and gold RF MEMS switch behavior,” Journal of Micromechanics and Microengineering, vol. 19, no. 10, pp. 2006-2015, 2007.

J. G. Simmons, “Generalized formula for the electric tunnel effect between similar electrodes separated by a thin insulating film,” Journal of Applied Physics, vol. 34, no. 6, pp. 1973-1803, 1963.

M. Vladimirescu, R. Kwiatkowski, and K. Engel, “Passive intermodulation distortion in RF coaxial electro-mechanical switches for space applications,” The 4th International ESA Multipactor, Corona and Passive Intermodulation Workshop, Noordwijk, Netherlands, 2003.

A. Z. Elsherbeni and V. Demir, The FiniteDifference Time-Domain Method for Electromagnetics with MATLAB Simulations. 2nd edition, The SciTech Publishing, UK, 2015.

T. J. Li, J. Jiang, T. T. Shen, and Z. W. Wang, “Analysis of mechanical properties of wire mesh for mesh reflectors by fractal mechanics,” International Journal of Mechanical Sciences, vol. 92, no. 3, pp. 90-97, 2015.

S. Y. Liao, “Measurements and computations of electric field intensity and power density,” IEEE Transactions on Instrumentation & Measurement, vol. 26, no, 1, pp. 53-57, 1977.

Downloads

Published

2021-07-22

How to Cite

[1]
Tuanjie Li, Wangmin Zhai, Xiangyang Li, Xiaofei Ma, and Jie Jiang, “A Finite Difference Time Domain Method for Passive Intermodulation Analysis of Nonlinear Metal-Metal Contact”, ACES Journal, vol. 33, no. 09, pp. 935–942, Jul. 2021.

Issue

Section

General Submission