Design of Shaped-Beam Parabolic Reflector Antenna for Peninsular Malaysia Beam Coverage and its Overlapping Feed Issues

作者

  • Nurul H. Abd Rahman Antenna Research Group, Microwave Technology Centre, Faculty of Electrical Engineering Universiti Teknologi MARA, Shah Alam, 40450, Selangor, Malaysia
  • Mohammad T. Islam Department of Electrical, Electronic and Systems Engineering, Faculty of Engineering and Built Environment Universiti Kebangsaan Malaysia, UKM Bangi, 43600, Selangor, Malaysia
  • Yoshihide Yamada Malaysia Japan International Institute of Technology Universiti Teknologi Malaysia Kuala Lumpur, Jalan Semarak, 54100 Kuala Lumpur, Malaysia
  • Naobumi Michishita National Defense Academy 1-10-20 Hashirhimizu, Yokosuka, Japan

关键词:

Antenna feeds, arrays, caustic model, ray tracing, reflector, satellite antenna

摘要

Design and performance of a shaped beam 12.2 GHz array-fed reflector antenna for broadcasting satellite is presented in this paper. Initial design, employing a cluster of feed horns illuminating a parabolic reflector is initially proposed for multi beam antenna (MBA) system to produce a contoured beam for Peninsular Malaysia. The precise feed positions are determined through a newly developed ray tracing program. Due to the small size of the coverage area, an issue with regards to physical constructability of the feed horns is raised. The MBA is modified by utilizing 18- element microstrip array as the feed, where each element positions are calculated by using the same caustic model. In this case, the preceding issue is solved, and high gain shaped beam coverage with uniform aperture is generated. This paper shows the results of the contoured beam antenna that have been achieved for beam scanned over a coverage size of approximately 0.9° long and 0.5° wide. Small variation of radiation level, which is less than 3dB within the edge of coverage (EOC), is also demonstrated in the performance analysis.

##plugins.generic.usageStats.downloads##

##plugins.generic.usageStats.noStats##

参考

Malaysian Communications and Multimedia Commission, Satellite Industry Developments, Cyberjaya, 2008.

J. R. Wertz and W. J. Larson, Space Mission Analysis and Design, 3rd edition, Microcosm, California, 1992.

C. C. Chen and C. F. Franklin, “Ku-band multiplebeam antenna,” NASA Contract Report 154364, NASA Langley Research Center, 1980.

E. R. Boudriau, “Multiple-beam antennas for military satellite communications systems,” DREO Technical Note 95-1, Defense Research Establishment, Ottawa, 1995.

M. Naderi and S. Campanella, “NASA’s advanced communications technology satellite (ACTS) - An overview of the satellite, the network, and the underlying technologies,” AAIA 12th International Communication Satellite Systems Conference, pp. 204-224, 1988.

A. Howell and D. Greenwood, “Antennas for Inmarsat III and beyond,” IEE Colloquium on Satellite Antenna Technology in the 21st Century, pp. 4/1-4/6, 1991.

R. Jorgensen, P. Balling, and W. J. English, “Dual offset reflector multibeam antenna for international communications satellite applications,” IEEE Transactions on Antennas and Propagation, vol. AP-33, no. 12, pp. 1304-1312, 1985.

M. Schneider, C. Hartwanger, and H. Wolf, “Antennas for multiple spot beam satellites,” CEAS Space Journal, vol. 2, no. 1-4, pp. 59-66, 2011.

N. J. G. Fonseca and J. Sombrin, “Multi-beam reflector antenna system combining beam hopping and size reduction of effectively used spots,” IEEE Antennas and Propagation Magazine, vol. 54, no. 2, pp. 88-99, 2012.

M. Mahajan, R. Jyoti, K. Sood, and S. B. Sharma, “A method of generating simultaneous contoured and pencil beams from single shaped reflector antenna,” IEEE Transactions on Antennas and Propagation, vol. 61, no. 10, pp. 5297-5301, 2013.

R. E. Collin and F. J. Zucker, Antenna Theory: Part 2, McGraw-Hill, New York, 1969.

C. J. Sletten, Reflector and Lens Antennas, Artech House, Massachusetts, 1988.

A. Garcia-Pino, N. Llombart, B. Gonzalez-Valdes, and O. Rubinos-Lopez, “A bifocal ellipsoidal Gregorian reflector system for THz imaging applications,” IEEE Transactions on Antennas and Propagation, vol. 60, no. 9, pp. 4119-4129, 2012.

W. V. T. Rusch and A. C. Ludwig, “Determination of the maximum scan-gain contours of a beamscanning paraboloid and their relation to the Petzval surface,” IEEE Transactions on Antennas and Propagation, vol. AP-21, no. 2, pp. 141-147, 1973.

C. A. Balanis, Antenna Theory: Analysis and Design, 3rd edition, John Wiley & Sons Inc., New Jersey, 2005.

N. H. Abd Rahman, M. T. Islam, N. Misran, Y. Yamada, and N. Michishita, “Design of a satellite antenna for Malaysia beams by ray tracing method,” International Symposium on Antennas and Propagation, pp. 1385-1388, 2012.

N. H. Abd Rahman, M. T. Islam, N. Misran, Y. Yamada, and N. Michishita, “Evaluation of caustics for parabolic reflector antennas through focal region ray tracings,” International Conference on Signal Processing and Communication Systems, pp. 1-4, 2013.

W. L. Stutzman and G. A. Thiele, Antenna Theory and Design, 2nd edition, John Wiley & Sons, New York, 1988.

S. Silver, Microwave Antenna Theory and Design, McGraw-Hill, New York, 1986.

Y. T. Lo, “On the beam deviation factor of a parabolic reflector,” IRE Transactions on Antennas and Propagation, vol. 8, no. 3, pp. 347-349, 1960.

##submission.downloads##

已出版

2021-08-22

栏目

General Submission