Numerical Investigation of Monitoring Antenna Influence on Shielding Effectiveness Characterization
关键词:
Dipole antenna, enclosure, shielding effectiveness, TLM wire model摘要
This paper deals with an impact of receiving antenna placed in a metal enclosure on an electromagnetic field distribution within the enclosure, and thus on its shielding effectiveness. In an experimental setup, a frequently used tool for measuring the electromagnetic field level at certain points within the enclosure is a dipole antenna connected to a measuring instrument via a coaxial cable. For modeling a coupling between the electromagnetic field and antenna in the protective enclosure we use the Transmission-Line Matrix (TLM) method, enhanced with the compact wire model. The numerical model is verified through comparison with the available experimental results and then used to investigate the influence of physical dimensions of dipole antenna and its cable connection on the detected level of shielding effectiveness.
##plugins.generic.usageStats.downloads##
参考
C. Christopoulos, “Principles and techniques of electromagnetic compatibility,” CRC Press, 2007.
H. A. Mendez, “Shielding theory of enclosures with apertures,” IEEE Trans. Electromagn. Compat., vol. 20, no. 2, pp. 296-305, 1978.
M. P. Robinson, T. M. Benson, C. Christopoulos, J. F. Dawson, M. D. Ganley, A. C. Marvin, S. J. Porter, and D. W. P. Thomas, “Analytical formulation for the shielding effectiveness of enclosures with apertures,” IEEE Trans. Electromagn. Compat., vol. 40, no. 3, pp. 240-248, 1998.
J. Shim, D. G. Kam, J. H. Kwon, and J. Kim, “Circuital modeling and measurement of shielding effectiveness against oblique incident plane wave on apertures in multiple sides of rectangular enclosure,” IEEE Trans. Electromagn. Compat., vol. 52, no. 3, pp. 566-577, 2010.
L. J. Nuebel, J. L. Drewniak, R. E. DuBroff, T. H. Hubing, and T. P. Van Doren, “EMI from cavity modes of shielding enclosures-FDTD modeling and measurements,” IEEE Trans. Electromagn. Compat., vol. 42, no. 1, pp. 29-38, 2000.
S. Ali, D. S. Weile, and T. Clupper, “Effect of near field radiators on the radiation leakage through perforated shields,” IEEE Trans. Electromagn. Compat., vol. 47, no. 2, pp. 367-373, 2005.
B. L. Nie, P. A. Du, Y. T. Yu, and Z. Shi, “Study of the shielding properties of enclosures with apertures at higher frequencies using the transmission-line modeling method,” IEEE Trans. Electromagn. Compat., vol. 53, no. 1, pp. 73-81, 2011.
N. Dončov, B. Milovanović, and Z. Stanković, “Extension of compact TLM air-vent model on rectangular and hexagonal apertures,” Applied Computational Electromagnetic Society (ACES) Journal, vol. 26, no. 1, pp. 64-72, 2011.
V. Milutinović, T. Cvetković, N. Dončov, and B. Milovanović, “Analysis of enclosure shielding properties dependence on aperture spacing and excitation parameters,” In Proceedings of the IEEE TELSIKS Conference, Niš, Serbia, vol. 2, pp. 521- 524, 2011.
J. Joković, B. Milovanović, and N. Dončov, “Numerical model of transmission procedure in a cylindrical metallic cavity compared with measured results,” Int. Journal of RF and Microwave Computer-Aided Engineering, vol. 18, no. 4, pp. 295-302, 2008.
A. J. Wlodarczyk, V. Trenkic, R. Scaramuzza, and C. Christopoulos, “A fully integrated multiconductor model for TLM,” IEEE Trans. Microwave Theory Tech., vol. 46, no. 12, pp. 2431- 2437, 1998.
T. Dimitrijević, J. Joković, B. Milovanović, and N. Dončov, “TLM modeling of a probe-coupled cylindrical cavity based on compact wire model in the cylindrical mesh,” Int. Journal of RF and Microwave Computer-Aided Engineering, vol. 22, no. 2, pp. 184-192, 2012.
C. Christopoulos, “The transmission-line modelling (TLM) method,” IEEE/OUP Series, Piscataway, NJ, 1995.
