Bi-Static Radar Cross-Section Test Method by using Historic Marconi Set-up and Time Gating

作者

  • Yousef Azizi Department of Electrical Engineering, Iran University of Science and Technology, Tehran 1684613114, Iran, Department of Electronics and Telecommunications, Politecnico di Torino, Turin 10129, Italy
  • Mohammad Soleimani Department of Electrical Engineering, Iran University of Science and Technology, Tehran 1684613114, Iran
  • Seyed Hasan Sedighy School of Advanced Technologies, Iran University of Science and Technology, Tehran 1684613114, Iran
  • Ladislau Matekovits 1) Department of Electronics and Telecommunications, Politecnico di Torino, Turin 10129, Italy 2) Department of Measurements and Optical Electronics, Politehnica University Timisoara, Timisoara 300006, Romania 3) Istituto di Elettronica e di Ingegneria del, l’Informazione e delle Telecomunicazioni, National Research Council, Turin 10129, Italy

##plugins.pubIds.doi.readerDisplayName##:

https://doi.org/10.13052/2022.ACES.J.370206

关键词:

RCS Measurement, time-gating, Marconi Set-Up

摘要

In this paper, a low-cost, simple, and reliable bi-static radar cross-section (RCS) measurement method by using a historic Marconi set-up is presented. It uses a transmitting (Tx) antenna (located at a constant position, at a reference angle of θ=0∘θ=0∘) and a moving receiver (Rx) antenna. A time gating method is used to extract the information from the reflection in the time domain; applying time filter allows removing the antenna side-lobe effects and other ambient noises. In this method, the Rx antenna (on the movable arm) is used to measure the reflected field in the angular range from 1∘1∘ to 90∘90∘ from the structure (printed circuit board, PCB) and the reference configuration represented by a ground (GND) plane of the same dimension. The time gating method is then applied to each pair of PCB/GND measurements to extract the bi-static RCS pattern of the structure at a given frequency. Here, a comparison of measurement results is carried out at 18 and 32 GHz with simulation ones indicating successful performance of the proposed method. It can be used as a low-cost, reliable, and available option in future measurement and scientificresearch.

##plugins.generic.usageStats.downloads##

##plugins.generic.usageStats.noStats##

##submission.authorBiographies##

##submission.authorWithAffiliation##

Yousef Azizi was born in Kermanshah, Iran, in 1989. He received his B.Ss degree in Electrical Engineering from Urmia University (UU), Urmia, Iran, in 2013. He also received his M.Sc. and Ph.D. degree all in Electrical Engineering from Iran University of Science and Technology (IUST), Tehran, Iran, in 2016 and 2021, respectively. He is currently a postdoctoral researcher in the Department of Electrical Engineering at ISUT. His major research interests are the design of Metasurface, Superstrate Antenna, planar and conformal Modulated surface for Radar Cross Section Reduction (RCSR).

##submission.authorWithAffiliation##

Mohammad Soleimani received the B.Sc. degree in electrical engineering from the University of Shiraz, Shiraz, Iran, in 1978, and the M.Sc. and Ph.D. degrees from Pierre and Marie Curie University, Paris, France, in 1981 and 1983, respectively.

He is currently a Professor with the School of Electrical Engineering, Iran University of Sciences and Technology, Tehran, Iran and serves as the Director with the Antenna and Microwave Research Laboratory. He has also served in many executive and research positions. He has authored and coauthored 19 books (in Persian) and more than 200 journal and conference papers. His research interests include electromagnetics and high-frequency electronics and antennas.

##submission.authorWithAffiliation##

Seyed Hassan Sedighy received the B.Sc., M.Sc., and Ph.D. degrees in electrical engineering from the Iran University of Science and Technology (IUST) in 2006, 2008, and 2012, respectively.

He is currently an Associate Professor with the School of Advanced Technologies, Iran University of Sciences and Technology. His current research interests include microstrips antenna, optical transformation, design and application of metamaterials, and RF radio links.

##submission.authorWithAffiliation##

Ladislau Matekovits received the degree in electronic engineering from Institutul Politehnic din Bucureşti, Bucureşti, Romania, and the Ph.D. degree (Dottorato di Ricerca) in electronic engineering from Politecnico di Torino, Torino, Italy, in 1992 and 1995, respectively.

Since 1995, he has been with the Department of Electronics and Telecommunications, Politecnico di Torino, first with a post-doctoral fellowship, then as a Research Assistant. He joined the same department as an Assistant Professor in 2002 and was appointed as a Senior Assistant Professor in 2005 and as an Associate Professor in 2014. In February 2017, he received the Full Professor qualification (Italy). In late 2005, he was a Visiting Scientist with the Antennas and Scattering Department, FGAN-FHR (now Fraunhofer Institute), Wachtberg, Germany. From July 1, 2009, for two years, he has been a Marie Curie Fellow with Macquarie University, Sydney, NSW, Australia, where, in 2013, he also held a Visiting Academic position and, in 2014, was appointed as an Honorary Fellow. Since 2020, he has been an Honorary Professor with the Polytechnic University of Timisoara, Romania and an Associate of the Italian National Research Council. He has been appointed as a Member of the National Council for the Attestation of University Degrees, Diplomas, and Certificates (CNATDCU), Romania, for the term 2020–2024.

His main research activities concern numerical analysis of printed antennas and, in particular, development of new, numerically efficient full-wave techniques to analyze large arrays, and active and passive metamaterials for cloaking applications. Material parameter retrieval of these structures by inverse methods and different optimization techniques has also been considered. In the last years, bio-electromagnetic aspects have also been contemplated, as, for example, design of implantable antennas or development of nano-antennas, for example, for drug delivery applications.

He has published 375+ papers, including 100+ journal contributions, and delivered seminars on these topics all around the world: Europe, USA (AFRL/MIT-Boston), Australia, China, Russia, etc. Prof. Matekovits has been invited to serve as Research Grant Assessor for government funding calls (Romania, Italy, Croatia, and Kazakhstan) and as International Expert in Ph.D. thesis evaluation by several universities from Australia, India, Pakistan, Spain, etc.

Dr. Matekovits has been a recipient of various awards in international conferences, including the 1998 URSI Young Scientist Award (Thessaloniki, Greece), the Barzilai Award 1998 (Young Scientist Award, granted every two years by the Italian National Electromagnetic Group), and the Best AP2000 Oral Paper on Antennas, ESA-EUREL Millennium Conference on Antennas and Propagation (Davos, Switzerland). He is a recipient of the Motohisa Kanda Award 2018, for the most cited paper of the IEEE Transactions on Electromagnetic Compatibility in the past five years, and, more recently, he has been awarded with the 2019 American Romanian Academy of Arts and Sciences (ARA) Medal of Excellence in Science and by the Ad Astra Award 2020, Senior Researcher, for excellence in research.

He has been an Assistant Chairman and Publication Chairman of the European Microwave Week 2002 (Milan, Italy) and General Chair of the 11th International Conference on Body Area Networks (BodyNets) 2016. Since 2010, he has been a member of the organizing committee of the International Conference on Electromagnetics in Advanced Applications (ICEAA), and he is a member of the technical program committees of several conferences. He serves as an Associated Editor for the IEEE AccessIEEE Antennas and Wireless Propagation Letters, and IET Microwaves, Antennas & Propagation and as a Reviewer for differentjournals.

参考

E. F. Knott, “Calibration,” in Radar Cross Section Measurements. New York, NY, USA: Van Nostrand Reinhold, pp. 183-187, 1993.

C. G. Bachman, H. E. King, and R. C. Hansen, “Techniques for measurement of reduced radar cross-sections,” Microwave Journal, vol. 6, no. 1, pp. 61-67, Feb. 1963.

W. A. Cummings, “Radiation measurements at radio frequencies: a survey of current techniques,” 27 Proceedings of the IRE, vol. 47, no. 5, pp. 705-735, May 1959.

P. D. Kennedy, “Equipment and techniques for the measurement of radar reflections from model targets,” WESCON Convention Record, pt. 1, pp. 208-215, 1957.

Special Issue on Ra2dar Reflectivity, Proceedings of the IEEE, vol. 53, no. 8, Aug. 1965.

A. Gorji, B. Zakeri, and R. C. Janalizadeh, “Physical optics analysis for RCS computation of a relatively small complex structure,” Applied Computational Electromagnetics Society Journal, vol. 29, pp. 530-540, July 2014.

C. Fang, X. Ye, Y. Zhang, Q. Wang, J. Zhao, N. Zhang, H. Jiang, C. Jin, and M. Bai, “Investigation of the RCS for finite bandpass frequency selective surface,”Applied Computational Electromagnetics Society Journal, vol. 34, no. 6, Jun. 2019.

J. R. Huynen, “Measurement of the target scattering matrix,”Proceedings of the IEEE, vol. 53, no. 8, pp. 936-946, Aug. 1965.

U. K. Chung, H. T. Chuah, and J. W. Bredow, “A microwave anechoic chamber for radar-cross section measurement,” IEEE Antenna and Propagation Magazine, vol 39, no. 3, pp. 21-26, Jun. 1997.

A. Soltane, G. Andrieu, and A. Reineix, “Monostatic radar cross-section estimation of canonical targets in reverberating room using time-gating technique,” in 2018 International Symposium on Electromagnetic Compatibility (EMC EUROPE), IEEE, pp. 355-359, 2018.

C. Larsson and M. Gustafsson, “Wideband measurements of the forward RCS and the extinction cross section,” Applied Computational Electromagnetics Society Journal, vol. 28, no. 12, Dec. 2013.

H. C. Marlow, D. C. Watson, C. H. Van Hoozer, and C. C. Freeny, ”The RAT SCAT cross-section facility,” Proceedings of the IEEE, vol. 53, no. 8, pp. 946-954, Aug. 1965.

I. D. Olin and F. D. Queen, “Dynamic measurement of radar cross-sections,”Proc. IEEE, vol. 53, no. 8, pp. 954-961, Aug. 1965.

C. F. Hu, N. J. Li, and C. H. Fang, “Application of spectral extrapolation technique to stepped-frequency RCS measurement,” Applied Computational Electromagnetics Society Journal, vol. 35, no. 9, Oct. 2020.

IEEE, 1502TM, “IEEE recommended practice for radar cross-section test procedures,” pp. 106-106, 1997.

M. G. Cote, “Automated swept-angle bistatic scattering measurements using continuous-wave radar,” IEEE Trans. Instrum. Meas., vol. 41, no. 2, pp. 185-192, Apr. 1992.

M. Z. Joozdani, M. K. Amirhosseini, and A. Abdolali, “Wideband radar cross-section reduction of patch array antenna with miniaturised hexagonal loop frequency selective surface,” Electron. Lett., vol. 52, no. 9, pp. 767-768, Apr. 2016.

A. A. Toscano, “Marconi’s representations of the wireless, In Marconi’s wireless and the rhetoric of a new technology,“ Springer, Dordrecht, pp. 57-85, 2012.

G. C. Corazza, “Marconi’s history,” Proc. IEEE, vol. 86, pp. 1307-1311, Jul. 1998.

A. V. Oppenheim and R. W. Schafer, Discrete-Time Signal Processing, NJ, Upper Saddle River: Prentice-Hall, 1989.

##submission.downloads##

已出版

2022-02-28

栏目

General Submission

##category.category##