Wideband Printed Antipodal Vivaldi Antenna using Straight Slots for UHF DVB-T/T2 Applications

作者

  • Na-Rae Kwon Department of Electronic Engineering, Gyeongsang National University (GNU), 501, Jinju-daero, Jinju, Gyeongnam, 52828, Republic of Korea
  • Seong-Hyeop Ahn Department of Electronic Engineering, Gyeongsang National University (GNU), 501, Jinju-daero, Jinju, Gyeongnam, 52828, Republic of Korea
  • Wang-Sang Lee Department of Electronic Engineering, Gyeongsang National University (GNU), 501, Jinju-daero, Jinju, Gyeongnam, 52828, Republic of Korea

##plugins.pubIds.doi.readerDisplayName##:

https://doi.org/10.13052/2022.ACES.J.370608

关键词:

antipodal Vivaldi antenna, DVB-T/T2, straight slots, UHF applications, wideband

摘要

This paper presents a wideband printed antipodal Vivaldi antenna using straight slots for UHF DVB-T/T2 applications covering a frequency range of 470–862 MHz. The proposed antenna consists of two radiation flares with straight slots and a feeding line. A wideband impedance matching was achieved by inserting the slots between the flares and the feeding line. For the experimental verification of the proposed antenna, it was fabricated on a flat circular printed circuit board (PCB) substrate with a radius of 0.25 λ0, where λ0 is the wavelength at 0.74 GHz (the center frequency of the operating band). The measured −10 dB impedance bandwidth and maximum gain were approximately 72.1% (0.47–1.00 GHz) and 2.57 dBi, respectively. Due to the addition of the slots, the impedance bandwidth of the proposed antenna was improved by approximately 212% compared with the Vivaldi antenna without slots.

##plugins.generic.usageStats.downloads##

##plugins.generic.usageStats.noStats##

##submission.authorBiographies##

##submission.authorWithAffiliation##

Na-Rae Kwon received the B.S. degree in electronic engineering from Gyeongsang National University (GNU), Jinju, South Korea, in 2017, where she is currently pursuing the M.S. degree.

Her current research interests include wireless power transfer and communication systems, RF/Microwave circuit and system, and RFID/IoT sensors.

##submission.authorWithAffiliation##

Seong-Hyeop Ahn received the B.S. and M.S. degrees in electronic engineering from Gyeongsang National University, Jinju, South Korea, in 2018 and 2020, respectively, and is currently working toward the Ph.D. degree.

His research interests are near- and far-field wireless power transfer and data communication system, high-power microwave system with slotted waveguides, and RF/microwave circuit and antenna designs.

##submission.authorWithAffiliation##

Wang-Sang Lee received the B.S. degree from Soongsil University, Seoul, South Korea, in 2004, and the M.S. and Ph.D. degrees in electrical engineering from the Korea Advanced Institute of Science and Technology (KAIST), Daejeon, South Korea, in 2006 and 2013, respectively. From 2006 to 2010, he was with the Electromagnetic Compatibility Technology Center, Digital Industry Division, Korea Testing Laboratory (KTL), Ansan-si, South Korea, where he was involved in the international standardization for radio frequency identification (RFID) and photovoltaic systems as well as electromagnetic interference (EMI)/EMC analysis, modeling, and measurements for information technology devices. In 2013, he joined the Korea Railroad Research Institute (KRRI), Uiwang-si, South Korea, as a Senior Researcher, where he was involved in the position detection for high-speed railroad systems and microwave heating for low-vibration rapid tunnel excavation system. Since 2014, he has been an Associate Professor with the Department of Electronic Engineering, Gyeongsang National University (GNU), Jinju, South Korea. From 2018 to 2019, he was a Visiting Scholar with the ATHENA Group, Georgia Institute of Technology, Atlanta, GA, USA. His current research interests include near- and far-field wireless power and data communications systems, RF/microwave antenna, circuit, and system design, RFID/Internet of Things (IoT) sensors, and EMI/EMC.

Dr. Lee is a member of IEC/ISO JTC1/SC31, KIEES, IEIE, and KSR. He was a recipient of the Best Paper Award at IEEE RFID in 2013, the Kim Choong-Ki Award– Electrical Engineering Top Research Achievement Award at the Department of Electrical Engineering, KAIST, in 2013, the Best Ph.D. Dissertation Award at the Department of Electrical Engineering, KAIST, in 2014, the Young Researcher Award at KIEES in 2017, and the Best Paper Awards at IEIE in 2018 and KICS in 2019.

参考

Bhattacharjee, A. Bhawal, A. Karmakar, A. Saha, and D. Bhattacharya, “Vivaldi antennas: a historical review and current state of art,” Int. J. Microw. Wirel. Tech., vol. 13, no. 8, pp. 833-850, 2021.

J. Puskely, J. Lacik, Z. Raida, and H. Arthaber, “High gain dielectric loaded Vivaldi antenna for Ka-band application,” IEEE Antennas Wirel. Propag. Lett., vol. 15, pp. 2004-2007, 2016.

Gazit and Ehud, “Improved design of the vivaldi antenna,” IEE Proceedings H-Microw., Antennas Propag., vol. 135, no. 2, pp. 89-92, 1988.

C. J. Hodgkinson, D. E. Anagnostou, and S. K. Podilchak, “Compact UWB antipodal vivaldi array for beam steering applications,” 2021 15th European Conf. Antennas Propag., pp. 1-5, 2021.

I. T. Nassar and T. M. Weller, “A novel method for improving antipodal Vivaldi antenna performance,” IEEE Trans. Antennas Propag., voil. 63, no. 7, pp. 3321-3324, 2015.

Z. Li, X. Kang, J. Su, Q. Guo, Y. Yang, and J. Wang, “A wideband endfire conformal Vivaldi antenna array mounted on a dielectric cone,” Int. J. Antennas Propag., vol. 2016, 2016.

X. Zhang, Y. Chen, M. Tian, J. Liu, and H. Liu, “A compact wideband antipodal Vivaldi antenna design,” Int. J. RF Microw. Comput.-Aided Eng., vol. 29, no. 4, pp. e21598, 2018.

H. Cheng, H. Yang, Y. Li, and Y. Chen, “A compact vivaldi antenna with artificial material lens and sidelobe suppressor for GPR applications,” IEEE Access, vol. 8, pp. 64056-64063, 2020.

S. Zhu, H. Liu, and P. Wen, “A new method for achieving miniaturization and gain enhancement of vivaldi antenna array based on anisotropic metasurface,” IEEE Trans. Antennas Propag., vol. 67, no. 3, pp. 1952-1956, 2019.

M. Sun, Z. N. Chen, and X. Qing, “Gain enhancement of 60-GHz antipodal tapered slot antenna using zero-index metamaterial,” IEEE Trans. Antennas Propag., vol. 61, no. 4, pp. 1741-1746, 2013.

X. Li, H. Zhou, Z. Gao, H. Wang, and G. Lv, “Metamaterial slabs covered UWB antipodal vivaldi antenna,” IEEE Antennas Wirel. Propag. Lett., vol. 16, pp. 2943-2946, 2017.

A. S. Dixit and S. Kumar, “A survey of performance enhancement techniques of antipodal vivaldi antenna,” IEEE Access, vol. 8, pp. 45774-45796, 2020.

S. Kumar, A. S. Dixit, R. R. Malekar, H. D. Raut, and L. K. Shevada, “Fifth generation antennas: A comprehensive review of design and performance enhancement techniques,” IEEE Access, vol. 8, pp. 163568-163593, 2020.

P. A. Dzagbletey, J. Shim, and J. Chung, “Quarter-wave balun fed vivaldi antenna pair for V2X communication measurement,” IEEE Trans. Antennas Propag., vol. 67, no. 3, pp. 1957-1962, 2019.

J. Schneider, M. Mrnka, J. Gamec, M. Gamcova, and Z. Raida, “Vivaldi antenna for RF energy harvesting,” Radioengineering, vol. 25, no. 4, pp. 666-671, 2016.

A. M. De Oliveira, A. M. de Oliveira Neto, and M. B. Perotoni, “A fern antipodal vivaldi antenna for near-field microwave imaging medical applications,” IEEE Trans. Antennas Propag., vol. 69, no. 12, pp. 8816-8829, Dec. 2021.

A. Alkhaibari, A. F. Sheta, and I. Elshafiey, “Notched antipodal vivaldi antenna for biomedical applications,” 2017 7th Int. Conf. Model. Simul. Appl. Optim., pp. 1-4, 2017.

R. Herzi, A. Gharsallah, M. A. Boujemaa, and F. Choubani, “Frequency reconfigurable Vivaldi antenna with switched resonators for wireless applications,” Int. J. Adv. Comput. Sci. Appl., vol. 10, no. 5, pp. 414-421, 2019.

F. Güneş, İ. Ö. Evranos, M. A. Belen, P. Mahouti, and M. Palandöken, “A compact triband antipodal Vivaldi antenna with frequency selective surface inspired director for IoT/WLAN applications,” Wireless Netw., vol. 27, pp. 3195-3205, 2021.

A. M. Abbosh, “Miniaturized microstrip-fed tapered-slot antenna with ultrawideband performance,” IEEE Antennas Wirel. Propag. Lett., vol. 8, pp. 690-692, 2009.

A. S. Dixit and S. Kumar, “A miniaturized antipodal vivaldi antenna for 5G communication applications,” 2020 7th Int. Conf. Signal Process. Integr. Netw., pp. 800-803, 2020.

Moosazadeh and Mahdi, “Sidelobe level reduction using teflon for a microwave and millimetre-wave antipodal vivaldi antenna,” IET Microw. Antennas Propag., vol. 14, no. 6, pp. 474-478, 2020.

M. Abbak, M. N. Akıncı, M. Ç ayören, and I. Akduman, “Experimental microwave imaging with a novel corrugated vivaldi antenna,” IEEE Trans. Antennas Propag., vol. 65, no. 6, pp. 3320-3307, 2017.

R. Natarajan, J. V. George, M. Kanagasabai, and A. Kumar Shrivastav, “A compact antipodal vivaldi antenna for UWB applications,” IEEE Antennas Wirel. Propag. Lett., vol. 14, pp. 1557-1560,2015.

Dastranj and Aliakbar, “Wideband antipodal vivaldi antenna with enhanced radiation parameters,” IET Microw. Antennas Propag., vol. 9, no. 15, pp. 1755-1760, 2015.

Z. Yin, G. He, X. Yang, and S. Gao, “Miniaturized ultrawideband half- mode vivaldi antenna based on mirror image theory,” IEEE Antennas Wirel. Propag. Lett., vol. 19, no. 4, pp. 695-699,2020.

Y. Dong, J. Choi, and T. Itoh, “Vivaldi antenna with pattern diversity for 0.7 to 2.7 GHz cellular band applications,” IEEE Antennas Wirel. Propag. Lett., vol. 17, no. 2, pp. 247-250, 2018.

Y. Liu, W. Zhou, S. Yang, W. Li, P. Li, and S. Yang, “A novel miniaturized vivaldi antenna using tapered slot edge with resonant cavity structure for ultrawideband applications,” IEEE Antennas Wirel. Propag. Lett., vol. 15, pp. 1881-1884, 2016.

P. Ludlow and V. F. Fusco, “Antipodal vivaldi antenna with tuneable band rejection capability,” IET Microw. Antennas Propag., vol. 5, no. 3, pp. 372-378, 2011.

H. Yu, S. Fang, L. Jiang, and H. Liu, “A full-band digital television transmitting antenna array with dual-layer bowtie dipole unit,” IEEE Access, vol. 8, pp. 102138-102145, 2020.

P. Duy Tung and C. W. Jung, “Optically transparent wideband dipole and patch external antennas using metal mesh for UHD TV applications,” IEEE Trans. Antennas Propag., vol. 68, no. 3, pp. 1907-1917, 2020.

C. Huang, B. Jeng, and J. Kuo, “Grating monopole antenna for DVB- T applications,” IEEE Trans. Antennas Propag., vol. 56, no. 6, pp. 1775-1776, 2008.

J. Y. Siddiqui, Y. M. M. Antar, A. P. Freundorfer, E. C. Smith, G. Morin, and T. Thayaparan, “Design of an ultrawideband antipodal tapered slot antenna using elliptical strip conductors,” IEEE Antennas Wirel. Propag. Lett., vol. 10, pp. 251-254,2011.

D. Oliveira, M. Alexandre, A. M. de Oliveira Neto, and M. B. Perotoni, “A fern antipodal vivaldi antenna for near-field microwave imaging medical applications,” IEEE Trans. Antennas Propag., vol. 69, no. 12, pp. 8816-8829, 2021.

##submission.downloads##

已出版

2022-06-30

##submission.howToCite##

[1]
N.-R. . Kwon, S.-H. . Ahn, 和 W.-S. . Lee, 《Wideband Printed Antipodal Vivaldi Antenna using Straight Slots for UHF DVB-T/T2 Applications》, ACES Journal, 卷 37, 期 06, 页 726–732, 6月 2022.

期

2022: Vol 37 Iss 6

栏目

General Submission

##category.category##