Broadband Permittivity and Permeability Extraction of Ferrite Cores up to the GHz Range via Measurements and Simulations
关键词:
Broadband model, EM-simulation, ferrites, material characterization, wireless power摘要
In this contribution a method is presented which allows for the characterization of the magnetic (mu’-j mu’’) as well as the dielectric (epsilon’-j epsilon’’) properties of ferrites in a broad frequency band (kHz to GHz). In order to determine the material properties at certain frequencies, the simulation model parameters of a particular test setup are tuned via optimization such that the simulated response of a sample to an electromagnetic excitation matches to the measured one. A loop and parallel plate setup support a low frequency parameter extraction of the sample while a coplanar line is used for high frequencies. The extracted material properties are fitted by a broadband causal fit in order to obtain a material model for the whole frequency range. The presented method is verified for a setup with a coil and a ferrite core. The results show that dielectric properties of the ferrite core cannot be neglected for microwave frequencies.
##plugins.generic.usageStats.downloads##
参考
R. Trevisan and C. Alessandra, “A UHF near-field link for passive sensing in industrial wireless power transfer systems,” IEEE Trans. Microw. Theory Tech., vol. 64, no. 5, pp. 1634-1643, 2016.
V. Radonić, N. Blaž, and L. Živanov, “Measurement of complex permeability using short coaxial line reflection method,” Acta Phys., pol. A, vol. 117, no. 4, pp. 820-824, 2010.
J. Xu, et al., “Measurement of electromagnetic parameters and FDTD modeling of ferrite cores,” 2009 IEEE Int. Symp. on Electromagn. Compat., pp. 83-88, 2009.
J. Baker-Jarvis, et al., “Measuring the permittivity and permeability of lossy materials: Solids, liquids, metals, building materials, and negative-index materials,” NIST Technical Note, National Institute of Standards and Technology, 2005.
Agilent Technologies Inc., “Solutions for measuring permittivity and permeability with LCR meters and impedance analyzers,” Application Note, Agilent Literature Number 5980-2862EN, 2014.
EPCOS AG, “Ferrites and accessories, P 26 x 16,” 2015. https://en.tdk.eu/tdk-en
EPCOS AG, “Ferrites and accessories, SIFERIT material N48,” 2015. https://en.tdk.eu/tdk-en
C. Reinhold, P. Scholz, and U. Jumar, “Electromagnetic material parameter extraction of ferrites up to the GHz range via measurements and simulations,” Applied Comp. Electromagn. Soc. (ACES) Symp., 2017 Int. IEEE, Italy, 2017.
M. D. Deshpande, et al., “A new approach to estimate complex permittivity of dielectric materials at microwave frequencies using waveguide measurements,” IEEE Trans. Microw. Theory Tech., vol. 45, no. 3, pp. 359-366, 1997.
V. Shemelin and N. Valles, “Improved accuracy of measurements of complex permittivity and permeability using transmission lines,” Nuclear Instruments and Methods in Physics Research Section A, 767, pp. 385-396, 2014.
M. Y. Koledintseva, et al., “Restoration of the Lorentzian and Debye curves of dielectrics and magnetics for FDTD modeling,” Int. Symp. 5th Electromagn. Compat., Europe, pp. 687-692, 2002.
K. P. Prokopidis, et al., “Improved propagation modeling in ultra-wideband indoor communication systems utilizing vector fitting technique of the dielectric properties of building materials,” 27th Annual Int. Symp. on Personal, Indoor, and Mobile Radio Comm. (PIMRC), IEEE, pp. 1327-1332, 2016.
