Simulation Validation of Experimental Tests for Automotive System EMC Developmental Tests
关键词:
Automotive engineering, EMC, pre compliance tests, radiated emissions摘要
The development and testing of automotive (sub)systems, particularly for Electromagnetic Compatibility (EMC), usually requires expensive test facilities. This paper describes the use of electromagnetic simulation to demonstrate the level of confidence that can be placed in measurements taken in more general laboratories, thus giving an estimate of the accuracy these facilities can provide. This is important in order to enable/allow more developments in automotive systems from research and development teams without standards compliant test facilities. This is, itself, important because of current developments in all-electric and autonomous vehicles. This paper demonstrates, through the use of full wave simulation representing a theoretically ideal environment compared with two different practical approaches, that EMC analysis can be undertaken with a reasonable estimation of accuracy and provides a framework for pre-compliance or developmental testing.
##plugins.generic.usageStats.downloads##
参考
W. T. Smith and R. K. Frazier, “Prediction of anechoic chamber radiated emissions measurements through use of empirically-derived transfer functions and laboratory common-mode current measurements,” Electromagnetic Compatibility, 1998. 1998 IEEE International Symposium on, vol. 1, pp. 387-392, August 1998.
British Standards Institute, “Radio disturbance characteristics for the protection of receivers used on board vehicles, boats, and on devices - Limits and methods of measurement,” BS EN 55025:2003 CISPR 25:2002, March 2003.
D. Schneider, M. Bottcher, S. Tenbohlen, and W. Kohler, “Pre-compliance test method for radiated emissions with multiple segment transfer functions,” International Symposium on Electromagnetic Compatibility (EMC EUROPE 2013), pp. 605-610, August 2013.
J. Jia, D. Rinas, and S. Frei, “Prediction of radiated fields from cable bundles based on current distribution measurements,” International Symposium on Electromagnetic Compatibility (EMC EUROPE 2012), pp. 1-7, September 2012.
J. Jia, D. Rinas, and S. Frei, “An alternative method for measurement of radiated emissions according to CISPR 25,” International Symposium on Electromagnetic Compatibility (EMC EUROPE 2013), pp. 304-309, September 2013.
D. Schneider, et al., “Transfer functions and current distribution algorithm for the calculation of radiated emissions of automotive components,” International Symposium on Electromagnetic Compatibility (EMC EUROPE 2013), pp. 443-448, September 2013.
Clayton R. Paul, “A comparison of the contributions of common-mode and differentialmode currents in radiated emissions,” Electromagnetic Compatibility, IEEE Transactions on, vol. 31, no. 2, pp. 189-193, May 1989.
D. Schneider, S. Tenbohlen, and W. Kohler, “Precompliance test method for radiated emissions of automotive components using scattering parameter transfer functions,” International Symposium on Electromagnetic Compatibility (EMC EUROPE 2012), pp. 1-6, September 2012.
D. Rinas, J. Jia, A. Zeichner, and S. Frei, “Substituting EMC emission measurement by field and cable scan method using measured transfer function,” Advances in Radio Science, vol. 11, pp. 183-188, July 2013.
