A 3 dB Coupler With Defected Ground Structure for Feeds Applied to High-Power Intelligent Metasurface

作者

  • Weidong Kong School of Electronic & Information Engineering Harbin Institute of Technology, Harbin 150001, China, Hebei Semiconductor Research Institute Shijiazhuang 050051, China
  • Jinyu Wang School of Electronic & Information Engineering Harbin Institute of Technology, Harbin 150001, China
  • Shixiong Deng Hebei Semiconductor Research Institute Shijiazhuang 050051, China
  • Qiaonan Wang School of Electronic & Information Engineering Harbin Institute of Technology, Harbin 150001, China, Hebei Semiconductor Research Institute Shijiazhuang 050051, China
  • Leiqiang Ma Southwest China Research Institute of Electronic Equipment Chengdu, China
  • Biao Zhou Hebei Semiconductor Research Institute Shijiazhuang 050051, China
  • Xuefeng Song Hebei Semiconductor Research Institute Shijiazhuang 050051, China
  • Kuang Zhang School of Electronic & Information Engineering Harbin Institute of Technology, Harbin 150001, China
  • Guohui Yang School of Electronic & Information Engineering Harbin Institute of Technology, Harbin 150001, China
  • Yang Li School of Integrated Circuits Shandong University, Shandong 250100, China
  • Cong Wang School of Electronic & Information Engineering Harbin Institute of Technology, Harbin 150001, China

##plugins.pubIds.doi.readerDisplayName##:

https://doi.org/10.13052/2026.ACES.J.410206

关键词:

3 dB coupler, defected ground structure (DGS), high power, metasurface

摘要

This paper proposes a 3 dB coupler with high-power handling capability feeds applied to high-power intelligent metasurface, based on loosely coupled structures and defected ground structure (DGS). The proposed coupler structure consists of two tandem coupled couplers with a coupling coefficient of 8.34 dB and a DGS, a design that significantly enhances the couplers’ ability to handle high power levels. The measurement results are in good agreement with the simulation results: within the 3.5 to 4.5 GHz range, the return loss exceeds 21.4 dB, the isolation is at least 20.8 dB, the insertion loss is less than 0.3 dB, and the phase difference between output ports is 93–94.5∘. Furthermore, the coupler can handle high power exceeding 1.5 kW with a 10% duty cycle. The proposed 3 dB coupler features low insertion loss, high isolation, low return loss, high-power capability, and can improve the power capability of intelligent metasurface systems.

##plugins.generic.usageStats.downloads##

##plugins.generic.usageStats.noStats##

##submission.authorBiographies##

##submission.authorWithAffiliation##

Weidong Kong received the B.E. and M.E. degrees in Electronics and Information Engineering from Harbin Institute of Technology University, China, in 2014 and 2016, respectively. He is currently pursuing a Doctor of Engineering degree with a specialization in Electronics and Information at Harbin Institute of Technology University.

##submission.authorWithAffiliation##

Jinyu Wang is currently pursuing the M.E. degree at Harbin Institute of Technology, China. His research specializes in microwave power amplifiers and filter design.

##submission.authorWithAffiliation##

Shixiong Deng received the M.E. degree from Beihang University, China, in 2014 and the Ph.D. degree from National University of Defense Technology in 2024. His research focuses on microwave limiters and electromagnetic protection.

##submission.authorWithAffiliation##

Qiaonan Wang received the M.E. degree from the University of Electronic Science and Technology of China. His research interests include microwave voltage-controlled attenuators and microwave filter design.

##submission.authorWithAffiliation##

Leiqiang Ma received the M.E. degree in Electronics and Information Engineering from Harbin Institute of Technology, China, in 2015. His research focuses on microwave receiver module design.

##submission.authorWithAffiliation##

Biao Zhou received the M.E. degree from Hebei Semiconductor Research Institute, China, in 2009. His research interests include microwave active phased array systems.

##submission.authorWithAffiliation##

Xuefeng Song received the M.E. degree from Hebei Semiconductor Research Institute, China. His research specializes in microwave semiconductor chips.

##submission.authorWithAffiliation##

Kuang Zhang (Member, IEEE) received the B.Sc. degree in electronics and information engineering, the M.Eng. degree in electronics engineering, and the Ph.D. degree in communication and information systems from Harbin Institute of Technology (HIT), Harbin, China, in 2005, 2007, and 2011, respectively. He was a Visiting Professor with the University of Wisconsin-Madison, Madison, WI, USA, from 2015 to 2016. Since 2010, he has been with the Department of Microwave Engineering, School of Electronics and Information Engineering, HIT, where he is currently a Professor.

##submission.authorWithAffiliation##

Guohui Yang (Member, IEEE) received the B.S. degree in telecommunication, the M.S. degree in instrument science and technology, and the Ph.D. degree in electromagnetics from the Harbin Institute of Technology, Harbin, China, in 2003, 2006, and 2009, respectively. Since 2009, he has been with the Department of Microwave Engineering, Harbin Institute of Technology, where he is currently an Associate Professor. His current research interests are radio frequency micro electromechanical system (RF MEMS) devices, tunable antennae, frequency selective surface (FSS), electromagnetic compatibility (EMC), and final difference time domain (FDTD).

##submission.authorWithAffiliation##

Yang Li (Senior Member, IEEE) received the Ph.D. degree from the Department of Electronic, Kwangwoon University, Seoul, South Korea, in 2015. He has been a Professor at the School of Microelectronics at Shandong University, Jinan, China, since 2022. His research interests include nanostructured flexible materials, flexible electronics, gas sensors, and memristors.

##submission.authorWithAffiliation##

Cong Wang (Senior Member, IEEE) was born in Qingdao, Shandong, China, in 1982. He received the B.S. degree in automation engineering from Qingdao Technological University, Qingdao, in 2005, and the M.S. and Ph.D. degrees in electronic engineering from Kwangwoon University, Seoul, South Korea, in 2008 and 2011, respectively. Since 2016, he has been with the Department of Microwave Engineering, Harbin Institute of Technology, Harbin, where he is currently a Professor. His major interests include passive device design and fabrication, humidity sensors, and biosensors.

参考

S. Yang, X. Wang, H. Zhu, and G. Lu, “A coupling-path reconfigurable quadrature coupler with wide range of tunable frequencies and power division ratios,” IEEE Transactions on Microwave Theory and Techniques, vol. 72, no. 6, pp. 3530–3541, June 2024.

F. Gardes, A. Shooa, G. De Paoli, I. Skandalos, S. Ilie, T. Rutirawut, W. Talataisong, J. Faneca, V. Vitali, and Y. Hou, “A review of capabilities and scope for hybrid integration offered by silicon-nitride-based photonic integrated circuits,” Sensors, vol. 22, no. 11, p. 4227, 2022.

Z.-B. Wang, X. Wei, H.-P. Fang, H.-M. Zhang, and Y.-R. Zhang, “A compact and broadband directional coupler for high-power radio frequency applications,” IEEE Microwave and Wireless Components Letters, vol. 30, no. 2, pp. 164–166, Feb. 2020.

S.-M. Sohn, A. Gopinath, and J. T. Vaughan, “A compact, high power capable, and tunable high directivity microstrip coupler,” IEEE Transactions on Microwave Theory and Techniques, vol. 64, no. 10, pp. 3217–3223, Oct. 2016.

H.-P. Fang and X. Wei, “Compact directional coupler for high-power applications,” in 2018 12th International Symposium on Antennas, Propagation and EM Theory (ISAPE), Hangzhou, China, pp. 1–3, 2018.

S. Li, L. Zhang, H. Xie, X. Yao, Z. Hao, and H. Dong, “Effect of AlN/Al2O3 thin-film protective layer on the high-temperature performance of ITO thin-film strain gauge,” IEEE Sensors Journal, vol. 23, no. 11, pp. 11490–11497, June 2023.

Z. Zhang, X. Yuan, and L. Xie, “A new package for SiC power modules with ceramic heatsink,” in 2022 IEEE Energy Conversion Congress and Exposition (ECCE), Detroit, MI, USA, pp. 1–7, 2022.

J. Zhang, Z. Wu, F. Xu, and D. Li, “An interdigitated coupler with defect ground structure,” in 2015 IEEE MTT-S International Microwave Workshop Series on Advanced Materials and Processes for RF and THz Applications (IMWS-AMP), Suzhou, China, pp. 1–3, 2015.

H. Hayashi, “Tandem Lange 3-dB 90∘ hybrid implemented on FR4 substrate,” in 2014 NORCHIP, Tampere, Finland, pp. 1–3, 2014.

K. Wincza, K. Staszek, and S. Gruszczynski, “Reduced-length tandem directional couplers composed of coupled-line sections with fixed coupling coefficient,” IEEE Transactions on Microwave Theory and Techniques, vol. 69, no. 3, pp. 1625–1634, Mar. 2021.

M. Abe, Y. Tahara, and N. Yoneda, “A tandem 3-dB hybrid coupler using coupled lines with series capacitance,” in The 40th European Microwave Conference, Paris, France, pp. 164–167, 2010.

R. Behera, K. Sangam, S. S. Lonkadi, A. Andhiwal, K. Singh, and A. V. Nirmal, “Realization of Lange coupler using hybrid technology and its characterization,” in 2022 Trends in Electrical, Electronics, Computer Engineering Conference (TEECCON), Bengaluru, India, pp. 135–141, 2022.

B. Qian, X. Chen, and A. Kishk, “Decoupling of microstrip antennas with defected ground structure using the common/differential mode theory,” IEEE Antennas and Wireless Propagation Letters, vol. 20, no. 5, pp. 828–832, May 2021.

M. Steer, Microwave and RF Design II—Transmission Lines. Raleigh, NC, USA: NC State University, p. 203, 2019.

G. Lin, X. Yin, S. Ren, Z. Wang, Y. Zhi, and T. He, “Compact and broadband directional coupler for high power applications,” Journal of Electromagnetic Waves and Applications, vol. 35, no. 15, pp. 1980–1986, 2021.

K. Abouhssous, L. Wakrim, A. Zugari, and A. Zakriti, “A compact patch coupler using cross-slots for 5G applications,” in 2023 IEEE 3rd International Maghreb Meeting of the Conference on Sciences and Techniques of Automatic Control and Computer Engineering (MI-STA), Benghazi, Libya, pp. 590–594, 2023.

J. Liu, Y. Wang, K. Ma, and W. An, “A differential SISPSL branch-line coupler with common-mode suppression using compensated stub,” IEEE Transactions on Circuits and Systems II: Express Briefs, vol. 70, no. 2, pp. 511–515, Feb. 2023.

##submission.downloads##

已出版

2026-02-20

##submission.howToCite##

[1]
W. . Kong, 《A 3 dB Coupler With Defected Ground Structure for Feeds Applied to High-Power Intelligent Metasurface》, ACES Journal, 卷 41, 期 02, 页 155–161, 2月 2026.

期

2026: Vol 41 Iss 2

栏目

Advances in Next-Generation Antenna Systems and Their Testing Methodologies

##category.category##