Appropriate extended functions for X-FEM simulation of elastic-plastic crack growth with frictional contact

Authors

  • Thomas Elguedj Laboratoire de Mécanique des Contacts et des Solides UMR 5514 INSA Lyon, Bât. Jean d'Alembert 18-20 rue des Sciences F-69621 Villeurbanne
  • Anthony Gravouil Laboratoire de Mécanique des Contacts et des Solides UMR 5514 INSA Lyon, Bât. Jean d'Alembert 18-20 rue des Sciences F-69621 Villeurbanne
  • Alain Combescure Laboratoire de Mécanique des Contacts et des Solides UMR 5514 INSA Lyon, Bât. Jean d'Alembert 18-20 rue des Sciences F-69621 Villeurbanne

Keywords:

non-linear fracture mechanics, extended nite element method, HRR elds, contact, friction

Abstract

The eXtended Finite Element Method (X-FEM) was used with success in the past few years for Linear Elastic Fracture Mechanics. In this paper one proposes to extend this method to fatigue crack growth analysis in the case of conned plasticity with treatment of frictional contact on the crack faces. A new plastic enrichement basis is therefore extracted from HRR elds and introduced in X-FEM coupled with an augmented Lagrangian formulation and a radial return method for plastic ow. Comparisons are made for mode I and mixed mode loading with a nite element code and show good agreements.

Downloads

Download data is not yet available.

References

Babuka I., Melenk J., « The Partition of Unity Method », International Journal for Numerical

Methods in Engineering, vol. 40, p. 727-758, 1997.

Belytschko T., Liu W., Moran B., Nonlinear nite element for continua and structures, 1st edn,

Wiley, Chichester, 2002.

Dolbow J., Moes N., Belytschko T., « An extended nite element method for modelling crack

growth with frictional contact », Computer Methods in Applied Mechanics and Engineering,

vol. 190, p. 6825-6846, 2001.

Fleming M., Chu Y. A., Moran B., Belytschko T., « Enriched element-free Galerkin methods

for crack tip elds », International Journal for Numerical Methods in Engineering, vol. 40,

p. 1483-1504, 1997.

Hutchinson J., « Singular behavior at the end of a tensile crack in a hardening material. »,

Journal of the Mechanics and Physics of Solids, vol. 16, p. 13-31, 1968.

Moes N., Dolbow J., Belytschko T., « A Finite Element method for crack growth without

remeshing », International Journal for Numerical Methods in Engineering, vol. 46, p. 131-

, 1999.

Pan J., « Asymptotic analysis of a crack in a power-law material under combined in-plane and

out-of-plane shear loading conditions », Journal of the Mechanics and Physics of Solids,

vol. 38, p. 133-159, 1990.

Rao B., Rahman S., « An enriched meshless method for non-linear fracture mechanics », International

Journal for Numerical Methods in Engineering, vol. 59, p. 197-223, 2004.

Ribeaucourt R., Baietto-Dubourg M., Gravouil A., « A mixed mode fatigue crack model for a

steady state non monotonous formulation », submitted to International Journal for Numerical

Methods in Engineering, 2005.

Rice J., Rosengren G., « Plane strain deformation near a crack tip in a power-law hardening

material », Journal of the Mechanics and Physics of Solids, vol. 16, p. 1-12, 1968.

Simo J., Laursen T., « An augmented lagrangian treatment of contact problems involving friction

», Computers and Structures, vol. 42, p. 97-116, 1992.

Downloads

Published

2006-06-11

How to Cite

Elguedj, T. ., Gravouil, A. ., & Combescure, A. . (2006). Appropriate extended functions for X-FEM simulation of elastic-plastic crack growth with frictional contact. European Journal of Computational Mechanics, 15(1-3), 155–166. Retrieved from https://journals.riverpublishers.com/index.php/EJCM/article/view/2125

Issue

Section

Original Article

Most read articles by the same author(s)

1 2 > >>