An RC filter for hydraulic switching control with a transmission line between valves and actuator

Authors

  • Rainer Haas Linz Center of Mechatronics GmbH, Altenbergerstraße 69, 4040 Linz, Austria
  • Evgeny Lukachev Linz Center of Mechatronics GmbH, Altenbergerstraße 69, 4040 Linz, Austria
  • Rudolf Scheidl Johannes Kepler University Linz, Institute of Machine Design and Hydraulic Drives, Altenbergerstraße 69, 4040 Linz, Austria

DOI:

https://doi.org/10.13052/14399776.2014.970974

Keywords:

digital hydraulics, hydraulic switching control, hydraulic RC filter, pulsation attenuation

Abstract

Hydraulic switching control with fast switching valves may excite unacceptable hydraulic and mechanical oscillations. Particularly if transmission lines are used, which have many oscillation modes, the avoidance of resonances by a proper timing of the switching pulses is hardly feasible. Then, passive filters may be a good solution. A simple RC filter applied to a cylinder drive with a transmission line to the switching valves is investigated by a transfer function analysis, numerical methods, and experiments. Properties of the dynamic behaviour are elucidated by approximate relations derived from the transfer function by asymptotic methods. A simple dimensioning rule recommends sizing the filter resistance close to the hydraulic impedance of the transmission line. The capacitance’s sizing is a trade off between a potential reduction of the resonance peak due to the cylinder natural frequency and a softness of the hydraulic drive system.

Downloads

Download data is not yet available.

References

Brown, F.T., 1987. Switched reactance hydraulics: a new way

to control fluid power. In: National conference on fluid

power. Chicago: NFPA, 25–34.

Brown, F.T., Tentarelli, S.C., and Ramachandran, S., 1988. A

hydraulic rotary switched-inertance servo-transformer.

ASME Journal of Dynamic Systems, Measurement, and

Control, 110 (2), 144–150.

D’Souza, A. and Oldenburger, R., 1964. Dynamic response of

fluid lines. ASME, Journal of Basic Engineering, 86,

–598.

De Negri, V.J., et al., 2014. Behavioural prediction of hydraulic

step-up switching converters. International Journal of Fluid

Power, 15 (1), 1–9.

Edge, K.A. and Johnston, D.N., 1990a. The secondary source

method for the measurement of pump pressure ripple characteristics.

Part 1 – Description of Method. Proceedings of

the Institution of Mechanical Engineers, Part I: Journal of

Systems and Control Engineering, 204, 33–40.

Edge, K.A. and Johnston, D.N., 1990b. The secondary source

method for the measurement of pump pressure ripple characteristics.

Part 2 – Experimental results. Proceedings of

the Institution of Mechanical Engineers, Part I: Journal of

Systems and Control Engineering, 204, 41–46.

Gradl, C. and Scheidl, R., 2013. A basic study on the response

dynamics of pulse-frequency controlled digital hdyraulic

drives. In: E. Barth, and A. Vacca, eds. The Bath/ASME

Symposium on Fluid Power & Motion Control,

FPMC2013, 6–9 October, Sarasota, Florida, paper ID:

FPMC2013-4438.

Hayward, A.T.J., 1976. A linear orifice-plate flowmeter.

Journal of Physics E: Scientific Instruments, 9,

–442.

HydroLib3, 2014. http://imh.jku.at [Accessed 20 June 2014].

Kogler, H., 2012. The Hydraulic Buck Converter – Conceptual

Study and Experiments. ACCM Schriftenreihe Advances in

Mechatronis, Bd. 16, Trauner Verlag, Linz.

Kojima, E. and Ichiyanagi, T., 1998. Development research of

new types of multiple volume resonators. In: C.R. Burrows,

and K.A. Edge, eds. 1st Bath Workshop on Power Transmission

and Motion Control (PTMC 1998), Bath, UK,

–206.

Kribayashi, T., et al., 2010. Research on the attenuation characteristics

of a multi-degree of freedom type Helmholtz Resonator

for hydraulic systems. Proceedings of Mechanical

Engineering Congress 2010 Japan, 7, 79–80.

Linjama, M., 2011. Digital fluid power – state of the art. In: H.

Sairiala, and K.T. Koskinen, eds. The Twelfth Scandinavian

International Conference on Fluid Power, 2 (4), SICFP’11,

–20 May, Tampere, Finland.

Linjama, M., Huova, M., and Vilenius, M., 2007. On stability

and dynamic characteristics of hydraulic drives with distributed

valves. In: D.N. Johnston, and A.R. Plummer, eds.

Power Transmission and Motion Control (PTMC 2007),

–14 September University of Bath, UK. 297–314.

Manhartsgruber, B., 2010. The influence of transmission line

dynamics on the performance of digital flow control units.

The third workshop on digital fluid power, DFP’10, 13–14

October 2010. Finland: Tampere, 107–118.

Mikota, J., 2001. A novel, compact compensator to reduce

pressure pulsations in hydraulic systems. In: Proceedings of

ICANOV – International conference on noise, acoustics

and vibration. Ottawa, Canada.

Ortig, H., 2005. Experimental and analytical vibration analysis

in fluid power systems. International Journal of Solids and

Structures, 42, 5821–5830.

Pan, M., et al., 2014. Theoretical and experimental studies of a

switched inertance hydraulic system. Proceedings of the

Institution of Mechanical Engineers, Part I: Journal of Systems

and Control Engineering, 228 (1), 12–25.

Plöckinger, A., Scheidl, R., and Huova, M., 2012. Simulation

and experimental results of PWM for digital hydraulics. In:

A. Laamanen, and M. Linjama, eds. The fifth workshop on

digital fluid power, DFP’12, 24–25 October, 2012. Tampere,

Finland, 133–152.

Scheidl, R., Garstenauer, M., and Manhartsgruber, B., 2000.

Switching type control of hydraulic drives – a promising

perspective for advanced actuation in agricultural machinery.

SAE-Technical Paper Series 2000-01-2559, Society of

Automotive Engineers.

Scheidl, R. and Hametner, G., 2003. The role of resonance in

elementary hydraulic switching control. Proceedings of the

Institution of Mechanical Engineers, Part I: Journal of Systems

and Control Engineering, 217, 469–480.

Scheidl, R., Lukachev, E., and Haas, R., 2014. A hydraulic

switching control concept exploiting a hydraulic low pass

filter. In: L.J. De Vin, and J. Solis, eds. The 14th mechatronics

forum international conference, 16–18 June,

Karlstad, Sweden.

Scheidl, R. and Kogler, H., 2013. Hydraulische Schaltverfahren:

Stand der Technik und Herausforderungen. Ölhydraulik

und Pneumatik, 57 (2), 6–18.

Suzuki, K., 1991. Improving Zielke’s method of simulating frequency-

dependent friction in laminar pipe flow. Journal of

Fluids Engineering, 113, 569–573.

Viersma, T.J., 1980. Analysis, synthesis and design of hydraulic

servosystems and pipelines (Studies in Mechanical Engineering).

Amsterdam: Elsevier.

White, P.R.S., et al., July-Sept 1984. The development of novel

linear air dampers for use in sea-wave energy converter

model tests. Transactions of the Institute of Measurement

and Control, 6 (4), 182–188.

Zielke, W., 1968. Frequency-dependent friction in transient pipe

flow. ASME Journal of Basic Engineering, 90 (1),

–115.

Downloads

Published

2018-12-29

How to Cite

Haas, R., Lukachev, E., & Scheidl, R. (2018). An RC filter for hydraulic switching control with a transmission line between valves and actuator. International Journal of Fluid Power, 15(3), 139–151. https://doi.org/10.13052/14399776.2014.970974

Issue

Section

Original Article

Most read articles by the same author(s)

1 2 > >>