APPLICATION OF EXTENDED KALMAN FILTER IN A METERING POPPET VALVE SYSTEM

Authors

  • Chang Li Rolf Fluid Power Lab, Mechanical and Aerospace Engineering University of Missouri-Columbia Columbia, Missouri 65211
  • Roger Fales Rolf Fluid Power Lab, Mechanical and Aerospace Engineering University of Missouri-Columbia Columbia, Missouri 65211

Keywords:

Extended Kalman Filter, metering poppet valve, robustness

Abstract

This work focuses on an accurate Extended Kalman Filter (EKF) estimator, which is applied to a forced-feedback metering poppet valve system (FFMPVS). The EKF estimator is used to estimate the position and velocity of the main poppet valve, position and velocity of the pilot poppet valve and pressures within the pilot stage of the valve. The EKF estimator takes advantage of its recursive optimal state estimation to estimate the states of this metering poppet valve by using one pressure signal measurement. The results from the EKF are compared with the simulation results from the model and also compared with the states which can be measured from the physical system set up in the lab. It is shown that the EKF estimator tracks the states accurately for both the steady-state and transient performance. The EKF estimator has robustness to parameter variations. It is shown specifically that the EKF estimator has robustness to an example of model uncertainty, variations in the spring stiffness parameter.

Downloads

Download data is not yet available.

Author Biographies

Chang Li, Rolf Fluid Power Lab, Mechanical and Aerospace Engineering University of Missouri-Columbia Columbia, Missouri 65211

Chang Li Received a B.S in Measurement, Control Technology and Instruments from Shanghai Jiao Tong University in 2004. Candidate for Ph.D in Department of Mechanical and Aerospace Engineering in University of Missouri- Columbia from 2006. His research focuses on system design, analysis and control related area.

Roger Fales, Rolf Fluid Power Lab, Mechanical and Aerospace Engineering University of Missouri-Columbia Columbia, Missouri 65211

Roger Fales Fales received B.S. and M.S. degrees in Mechanical Engineering at Kansas State University in 1996 and 1998 respectively. He was employed at Caterpillar Inc. from 1998 to 2002 as a research engineer. At Iowa State University, he received a Ph.D. in Mechanical Engineering in 2004. In 2004, he joined the Mechanical & Aerospace Engineering Department at the University of Missouri – Columbia. As an assistant professor, he teaches and does research work in the areas of dynamics, systems, automatic control, and fluid power.

References

Acarnley, P. P. and AI-Tayie, J. K. 1997. Estimation

of speed and armature temperature in a brushed DC

drive using the extended Kalman filter. Electric

Power Application, IEE Proceedings, Vol. 144, Issue

, pp. 13-20.

An, L. and Sepehri, N. 2005. Hydraulic Actuator

Leakage Fault Detection Using Extended Kalman

Filter. International Journal of Fluid Power, Vol. 6,

pp. 41-51.

Chinniah, Y., Burton, R. and Habibi, S. 2003. Viscous

Damping Coefficient and Effective Bulk

Modulus Estimation in a High Performance Hydrostatic

Actuation System using Extended Kalman

Filter. International Journal of Fluid Power, Vol. 4,

No. 3, pp. 27-34.

Fales, R. and Li, C. 2008. Experimental Evaluation of

a Metering Poppet Valve. Bath/ASME Symposium

on Fluid Power & Motion Control, Bath, UK.

Manring, N. D. 2005. Hydraulic Control Systems.

John Wiley and Sons, New Jersey, pp. 224-228.

Muller, M. and Fales, R. 2008. Design and Analysis of

a Two-Stage Poppet Valve for Flow Control. International

Journal of Fluid Power, Vol. 9, No. 1, pp.

-26.

Walchko, K. J., Novick, D. and Nechyba, M. C. 2003.

Development of a Sliding Mode Control System

with Extended Kalman Filter Estimation for Subjugator.

Florida Conference on Recent Advances in

Robotics, FAU, Dania Beach, FL.

Zhuang Xu. and Rahman, M. F. 2003. An Extended

Kalman Filter Observer for the Direct Torques Controlled

Interior Permanent Magnet Synchronous

Motor Drive. Power Electronics and Drive Systems,

The Fifth International Conference. Vol. 1, pp. 686-

Downloads

Published

2009-11-01

How to Cite

Li, C., & Fales, R. (2009). APPLICATION OF EXTENDED KALMAN FILTER IN A METERING POPPET VALVE SYSTEM. International Journal of Fluid Power, 10(1), 17–25. Retrieved from https://journals.riverpublishers.com/index.php/IJFP/article/view/503

Issue

Section

Original Article